Body-Pack Transmitter Mic. Input : Head-set mic. or tie-clip mic. in-put jack. | LED Indicator : Shows power and operation status of microphones red light-on when less power, Antenna : RF signal transmitter. Power Switch : Used to turn-on or turn-off microphone power, three power settings : off, stand-by , on. Fixed lock — Mic. Vol : Adjusts the volume level which transmitted from the radio transmitter, I Brit Clip : Used to hang the radio transmitter on bait.
A. Single channel (Type-A) 1.Power indicator 2.RF Signal indicator 3.AF Signal indicator 4.Power switch 5.Volume control B. Dual channel {Type-B) TE 3 ame £2 ET 6.Squelch control 7.AF Output B. Channe) selection 9.DC Power socket 10.Antenna {EJ-802R} 1 ] 12 1.Power indicator 2.Ch.1 RX Signal indicator 3.Ch.1 AF Signal indict, 6.Antenna B 7.Volume control B squelchy control Mss 7 13.8queich control A 14.AF Output A 15.Channel selection 16.DC Power socket 17.Antenna A C.
E. Microphone Specification (hand-held) / (lavaliere) Mike (hand-held) Dynamic microphone Mike {lavaliere) oa I at set, OT Guitar cable] Antenna Built-in RF output 10 mW (according to regulation} Spurious emissions 60 dBc Battery type Ni-CD rechargeable battery Battery life 8 ~ 10 Hours {Use 1300mA} Dimensionless 1} 54x237mm / 92x65x25mm Weight 230g ; 80g Battery indicator Red LED batty low display Stand-by switch ON— STY = OFF Att 1.
H. Applications 1.Please turn to minimum volume of receiver and amplifier when turn on/off power for protecting machines. 2.Turn on receiver power ,power LED light up, indicating power input normally. 3.Turn on wireless microphone power, red LED gleam indicating power input normally, if LED lights up lasting ,indicating the power of battery is low and need to be replaced. 4.RF LED light up,indicating signal reception normally. 5.Adjust the receiver volume to proper level. 6.