User's Manual

EJ-601TM

operating instructions :

2.4G wireless digital handheld microphone

1.mesh grille 7.Mute/Talk switch

2.Handheld tube 8.Battery compartment

3.Power indicator 9.Battery door)

4.On/Off button 10.Master/Slave switch

5.LCD display shows channel, battery meter 11.(Charging contacts

6.UP/DOWN/SET wheel

2.4G wireless digital handheld microphone setup

1.Remove batteries, set Master/Slave switch (10) to a desired position.

※When Mic is set to Master, ch A will be a designated channel.If ch A is unavailable, it will change to

ch B as a result.

※When Mic is set to Slave, ch B is the designated channel, which will be displayed in screen.

2.Set Mute/Talk, Push/Talk through software

※Pres

s and hold SET button then turn on handheld microphone to enter setup mode. The screen will

flash “MT” or “PT” for option through UP or DOWN .

3.Press and hold power button for about 1 second to power on. Then power indicator (3) will illuminate.

※Blue power indicator stands for enough battery power; red indicator stands for low battery.

4.Channel synchronization

1. Synchronization will be made once when the unit is turned on.

2. When synchronization is made successfully, channel number will be displayed in LCD and mute

button will light blue. If synchronization is failed, LCD screen will show battery meter and blan

annel number, mute button will light red.

※Synchronization works in the range of 15 meter.

PAGE 1
EJ-601TM operating instructions : 2.4G wireless digital handheld microphone 1.mesh grille 7.Mute/Talk switch 2.Handheld tube 8.Battery compartment 3.Power indicator 9.Battery door) 4.On/Off button 10.Master/Slave switch 5.LCD display shows channel, battery meter 11.(Charging contacts 6.UP/DOWN/SET wheel 2.4G wireless digital handheld microphone setup 1.Remove batteries, set Master/Slave switch (10) to a desired position. ※When Mic is set to Master, ch A will be a designated channel.
PAGE 2
※Handheld microphone will turn off automatically when no call from synchronization request after 30 minutes. 5.Set Mute or Talk function through Mute/Talk button. ※In Talk mode, Blue indicator for Talk; Red indicator for Mute ※In Push mode, Blue indicator for Talk,Red indicator for Mute 6.Turn handheld microphone off by pressing and holding power button (4) for 2-3 seconds. 7.Insufficient battery power will have an influence on signal transmission. Make sure the applied batteries are good with enough power.