User's Manual
【Quick Installation Guide─AllCam x Baby Temperature Monitor v1.0】
1 QIG 08-2017 / v1.0
Warm Reminders:
1. Please install the Gateway.
2. Pairing RF Sensors with the Gateway.
Please Prepare:
1. First time installation, network requirement: Gateway on the same Wi-Fi router as the
smartphone/tablet.
2. Required Application: “ALLCAM” APP
Gateway Installation
1. 【First-Time Installation】
1.1. Install " AllCam " APP: Search for “ALLCAM”
on GooglePlay / Apple Store or scan the QR Code on the right.
Please download and install the APP.
1.2. Plug in the power and the indicator light will be red.
1.3. After the Gateway has been powered for about 15 seconds, the indicator light will flash
green/red. (meaning it has entered AP-mode) When you see the flashing light, follow the steps below.
1.4. Connect to the Gateway AP point by going to the Wi-Fi options on your smartphone/tablet.
(Pic.1) Find and connect to:
“AllCam-XX:XX:XX:XX:XX:XX” (The actual MAC address will be displayed.), and enter the
password “12345678”.
1.5. After connecting to the Gateway AP, launch the installed APP “ALLCAM”:
1.5.1 When you see “Do you want to connect to Wi-Fi Router?” (Pic.2), If you have an
internet-ready Wi-Fi Router please press “OK”. When you see the Configuration-Wireless screen,
please select your Wi-Fi point (Pic.3) and connect to your router by entering your Wi-Fi password.
1.5.2 After connecting the Gateway to your router, wait about 30 to 40 seconds, when you see
(Pic.4) “Camera List” it means the installation was successful. The indication light on the
camera will turn solid green to indicate the same.
(If the password was incorrect, please wait for the Gateway to return to AP-Mode, and try
again.)
1.5.3 If you do not have an internet-ready Wi-Fi router, press “Cancel”. Then click on the
according Gateway under “Camera List”. Please note that it will not have any function outside the
local area and you will not receive any push notifications when a sensor is triggered.
(Pic.1) (Pic.2) (Pic.3)
2. 【Adding a New User, After Installation】
2.1. Please first download and install the “ALLCAM” APP, you can find it in the Apple Store /Google
Play.
2.2. Please connect your smartphone/tablet to the same Wi-Fi router as the Gateway.
2.3. Launch the “ALLCAM” App, select “Add Camera” (Pic.4) and allow the system around 15
seconds to automatically scan for available Gateways.
2.4. Please select the according Gateway with your UID and select it (Pic.5), on the next screen
please enter your Gateway password (default is “admin”) and enter a name (Pic.6). Then select the
check mark to complete adding a new user.
(If adding multiple gateways, please repeat from step 2.1)
(Pic.4) (Pic.5) (Pic.6))