User's Manual

Before enjoying the pleasure it provides, please take a
moment to read this user manual carefully.
Instruction Manual
Speci�ications:
Category: Remote Control Bullet Vibrator
Materials: Bullet Egg-Silicone; Remote-Silicone+ABS Plastic
Users: Female, couples
Size: Bullet Egg:7.64*1.3 inch; Remote:2.36*0.78 inch
Weight: Bullet Egg:1.8 oz; Remote:1.23 oz
Number of vibration modes: 7
Battery type: Li-ion(including USB charging cable)
Charging voltage: 5V
Water resistant: Bullet Egg-Waterproof;
Remote-Not Waterproof
Charging voltage: 5V
Note: Please do not turn on the product
when charging.
USER MANUAL
Recharging:
1. Please use the original USB charging cable came with the
box.
2. Please make sure the DC port is away from water or lube
before charging.
3. The USB cable can be charged by any USB adapters for
mobile phones, the USB port from laptop, PC or power
bank.
4. It usually takes 2 hours to charge it.
5. The button/LED light blinks when charging and it
goes solid when it’s fully charged.
6. The egg’s button light is not very obvious in a
bright room. Please observe it in the dark.
Preservation:
1. Please clean and dry the toy after every use.
2. Turn off the toy if not in use.
3. Do not expose the toy to direct sunlight or extreme
heat. Keep in a safe, dry and dust-free place.
4. Keep the toy away from contact with material of
other toys.
Cleaning:
1. Before the �irst-time use, please clean the toy carefully
and thoroughly.
2. Clean the toy with warm water and antibacterial soap.
3. Please do not use cleaners that contains alcohol, petrol
or acetone.
4. Please do not soak the item in water for long time.
5. Please turn off the product before cleaning.
6. Please do not clean the toy when charging.
2 3
5 6 74
1
How to use this product?
1. In order to turn it on, you have to SEPARATELY press the
button of the remote and bullet egg for 3 seconds. When
it's turn on, the remote's LED light will stay solid while
the egg’s button will �lash.
2. After turned on, you can press the remote button to
change the egg's vibrations. The remote's LED light
will change if you switch the vibration modes.
There is a standby mode(no vibration, just light �lashing)
after you switch around the 7 vibration modes. Press again,
it will start vibrating again.
3. To turn it off, SEPARATELY press
the button of the remote and
bullet egg for 3 seconds.
4. To recharge, use the USB
charging cord(came with the
box) to charge it. The LED light
will keep �lashing until both
parts get fully charged.
Warranty:
1. We offer a one-year guarantee from the date of its
purchase. Customers are responsible for the shipment
fee if replacement is needed.
2. Please always follow the instructions.
3. Warranty does not cover the neglect or misuse of the
product. Any attempt to open or take apart the sex toy
will void the warranty.
4. The warranty does not violate any legal rights of
consumers.
FCC Warning
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Any changes or modi�ications not expressly approved
by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio requency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
 -Reorient or relocate the receiving antenna.
 -Increase the separation between the equipment and receiver.
 -Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
 -Consult the dealer or an experienced radio/TV technician
for help.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Note: