Installation Guide

THREAD SEAL TAPE
INSTRUCTION GUIDE
2
3
4
1
Separate some tape from the roll.
Wrap the tape around the thread in a clockwise motion
being sure to cover the threads completely.
After completing the recommend number of revolutions
around the thread, simply pull the roll and the tape will
snap free easily.
Your pipe is ready to be threaded into the tting.
©2020 Oatey SCS. All Rights Reserved. This information is based on data believed to be reliable but Oatey makes no warranties, express or implied, as to its accuracy and assumes no liability arising out
of its use. The data listed falls within the normal range of product properties but should not be used to establish specication limits or used alone as the basis of design. Oatey’s liability to purchasers is
expressly limited to the terms and conditions of sale. Oatey is trademark of Oatey Co. All other trademarks can be found www.Oatey.com.
Oatey.com