2007.07.
O ROKR™ PRO Introducing O ROKR Pro, the world’s first eyewear to stream digital music. Even better, O ROKR Pro lets you wirelessly control the music. Just use the buttons on the frame to select songs on your Bluetooth® music-streaming mobile phone or portable music player. (NOTE: A small add-on Bluetooth adapter may be required.
IMPORTANT: READ ALL INCLUDED SAFETY INFORMATION BEFORE USING O ROKR PRO. INTRODUCTION O ROKR Pro gives you a mobile, wearable link to your Bluetooth enabled mobile phone with no cords or wires to get in the way. With the ability to stream digital music, O ROKR Pro works like wireless stereo headphones and even lets you control the music wirelessly. Just use a mobile phone with music streaming capability or add a Bluetooth adapter to your portable music player.
CHARGING THE BATTERY Charge O ROKR Pro for 3 hours before using it the first time. (For normal recharging, a fast charge of 1.5 hours will charge the battery to 80% capacity; 3 hours will provide a full charge.) When fully charged, O ROKR Pro provides over 100 hours of standby time or 5 hours of talk time. If O ROKR Pro hasn’t been used for a while, the battery may need recharging. When the battery is low, you will hear warning tones every 60 seconds. O ROKR Pro comes with a wall charger.
PAIRING WITH YOUR PHONE AND/OR MUSIC DEVICE Before you can use O ROKR Pro to make a call, it must be paired with your Bluetooth enabled phone and/or music device. This is a onetime task. Once pairing is complete, O ROKR Pro automatically connects to your phone and/or music device whenever you turn O ROKR Pro on. EASY PAIRING O ROKR PRO 1. Power on the headset by pressing the Call button. After a few moments, the indicator light will be steadily lit in red to indicate the headset is in pairing mode.
TURNING O ROKR PRO ON AND OFF To turn O ROKR Pro on: Press and hold the Call button for approximately three seconds until you hear four audio tones rising in pitch, or you see the indicator light flash red > amber > green > green. To turn O ROKR Pro off: While O ROKR Pro is not being used for an active call, press and hold the Call button for approximately three seconds until you hear four audio tones descending in pitch, or you see the indicator light flash green > amber > red > red.
MAKING AND RECEIVING CALLS In addition to the volume buttons, the Call button is all you need to use O ROKR Pro with your phone. USING O ROKR PRO FOR CALLS TURN O ROKR PRO ON Press and hold the Call ANSWER A CALL Press the Call ADJUST VOLUME button for 3 seconds. button briefly. Press the Volume Up button repeatedly to increase the volume. Press the Volume Down button repeatedly to decrease the volume.
CONTROLLING MUSIC Use O ROKR Pro to wirelessly control music from your Bluetooth music-streaming phone or music player. If a call comes in while music is playing, just press the Call button on O ROKR Pro to pause the music and take the call. After the call is finished, press the Call button again to go back to where you left off in the music.
INDICATOR LIGHT The indicator light on O ROKR Pro provides the following information: DURING PAIRING The light is solid red. It to flashes green ten times when pairing is successful. DURING CHARGING Solid green = fully charged Solid amber = 99% to 50% charged Solid red = 49% to 0% charged WHILE WIRELESSLY CONNECTED TO A DEVICE The light flashes every 4 seconds: Green indicates 100% to 67% charge remaining. Amber indicates 66% to 34% charge remaining. Red indicates 33% to 0% charge remaining.
OAKLEY FRAME AND LENS TECHNOLOGY You're now wearing the best eye protection on earth. Only Oakley utilizes pure Plutonite® lens material, a proprietary synthetic that exceeds the optical requirements of ANSI Z87.1 standards while inherently blocking 100% of all UVA, UVB, UVC and harmful blue light.
CHANGING THE LENSES The lenses of O ROKR Pro can be easily changed. The instructions below show you how to remove the current lenses and install a different set. WARNING: Follow these instructions carefully. Failure to do so may adversely affect optical performance. Improperly installed lenses may fail to stay in place, causing interference with your vision. To remove the lenses: 1 2 1. Hold the frame upside down as shown in Figure 1. Grip the lens with one hand.
SAFETY AND GENERAL INFORMATION IMPORTANT INFORMATION ON SAFE AND EFFICIENT OPERATION. READ THIS INFORMATION BEFORE USING YOUR DEVICE. O ROKR Pro complies with part 15 of the FCC Rules. Operation is subject to the following conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. See 47 CFR sec 15.19 (3).
PROPER CARE OF YOUR O ROKR PRO DO NOT MODIFY OR DISMANTLE Do not attempt to open O ROKR Pro. Doing so may expose you to electric shock and serious injury. There are no user-serviceable parts inside. Any attempt to alter or repair the unit will void the limited warranty. Users are not permitted to make changes or modify the device in any way. Changes and modifications void the user's authority to operate the device. See 47 CFR Sec. 15.21. BATTERY Do not attempt to remove the internal rechargeable battery.
SPECIFICATIONS Bluetooth Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . BT 2.0, backward compatible with 1.2 Bluetooth Profiles. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Handsfree, Headset, A2DP, AVRCP Speaker Positioning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
SERVICE AND SUPPORT If OROKR Pro does not function, follow the instructions under “Troubleshooting” in this user guide. In addition, go to www.oakley.com for the latest support information on OROKR Pro. If OROKR Pro still does not function, follow the procedures below to make a warranty claim. OAKLEY LIMITED WARRANTY In the United States, OROKR Pro is warranted against manufacturer’s defects for 1 year from the date of purchase. Outside of the U.S.
OBTAINING WARRANTY SERVICE The defective product must be returned to Oakley by the owner with a Return Authorization (RA) number and a dated proofof purchase from an authorized Oakley OROKR Pro dealer. Call Oakley Customer Service at 800-403-7449 (U.S.) to request an RA number. Based on the information you provide, Customer Service will determine if an RA number should be issued. Credit card information must be provided for Customer Service to issue an RA number.
STATEMENT ACCORDING TO FCC PART 15.105: NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.