User's Manual

WARNING!
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER ON THIS
SPEAKER.
THERE ARE NO USER-SERVICEABLE PARTS INSIDE. REFER ALL SERVICING TO A QUALIFIED
TECHNICIAN.
The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert
the user to the presence of dangerous voltage within the products enclosure that may be of
sufficient magnitude to constitute a risk of electric shock to humans. Users should exhibit
extra safety when this symbol appears in this instruction manual and follow all precautions as
they are stated.
The exclamation point within an equilateral triangle is intended to alert the user to the
presence of important operating and maintenance (servicing) instructions in this manual.
1- Read these instructions.
2- Keep these instructions.
3- Heed all warning.
4- Follow all instructions.
5- WARNING: To prevent fire or electric shock, do not expose this equipment to rain or
moisture. Do not shore or operate this product near any liquids.
6- Clean only with a dry cloth.
7- Do not store or operate this product near any heat sources such as radiators, heat registers,
stoves, or other apparatuses (including amplifiers) that produce heat. Keep this product in a
well ventilated area.
8- Do not defeat the safety purpose of the polarized or pounding-type plug. A polarized plug
has two blades with one wider than the other. A grounding plug has two blades and a round
grounding prong. The wide blade or third prong is provided for your safety. If the provided
plug does not fit your outlet, consult an electrician for the replacement of the obsolete outlet.
9- Protect all the wires connected to this unit from being walked on or pinched, particularly
plugs and the point where they exit from the unit. When removing the cord from the power
outlet, remove it by holding the plug, not by pulling the cord.
10- Unplug the unit during lightning storms or when unused for long periods of time.
11- When wiring this unit and all other equipment used in connection to this unit make sure
that all of your equipment is turned OFF.
12- Once installation and wiring is complete power on all your equipment with the volume
and level controls turned DOWN. Once all the equipment is ON slowly raise the volume or
level controls to their proper positions.
13- Before Placing, Installing, rigging, or suspending any product, inspect all hardware,
suspension, cabinets, transducers, brackets and associate equipment for damage. Any missing,
corroded, deformed, or non-load rated component could significantly reduce the strength of
the installation, placement or array. Any such condition severely reduces the safety of the
installation and should be immediately corrected. Use only hardware which is rated for the
loading conditions of the installation and any possible short-term, unexpected overloading;

Summary of content (8 pages)