Spec Sheet

Network Video Technologies
4005 Bohannon Drive • Menlo Park, CA 94025 • USA
(+1) 650.462.8100 • 800.959.9870 • FAX [phone]
nvt.com • [e-mail]
-26-
Model NV-716J-PVD
Cable Integrator Hub
Features:
• Connectivity for up to sixteen cameras, each via a single RJ45 4-pair cable
• Use with the NV-216A-PV, NV-218A-PVD, or NV-226J-PV transceiver at the camera
• Uses any third-party power supply to power cameras via UTP over significant
distances (see Power Distance Chart)
• Cable-management solution from the camera to the Wiring Closet and on to
the Control Room
• 1U high; 1" deep; wall or rack-mountable
• Limited lifetime warranty
Typically installed in the wiring closet or IDF room, the NV-716J-PVD is a passive “pass-through” wiring
device that efficiently consolidates camera power, video, and pan/tilt/zoom telemetry data onto a mini-
mum of 4-pair RJ45 cables.
Power, video and data are converted at the camera using a PVD
TM
transceiver which utilizes a single 4-
pair cable with RJ45 connectors to deliver each camera’s signals to the NV-716J-PVD. Up to sixteen
cameras are supported. The NV-716J-PVD receives low-voltage camera power from any third-party
multi-output Class 2 power supply. Control Room connections are achieved with a single 4-pair RJ45
cable for each group of four cameras. P/T/Z telemetry data, if required, passes through another 4-pair
RJ45 cable. Control Room connections may be made using any multi-channel NVT receiver or hub. All
equipment employs industry-standard EIA/TIA 568B pinouts.