Spec Sheet
Network Video Technologies
4005 Bohannon Drive • Menlo Park, CA 94025 • USA
(+1) 650.462.8100 • 800.959.9870 • FAX (+1) 650.326.1940
nvt.com • info@nvt.com
-51-
Features:
• Four passive transceiver channels in one product
• Full-motion CCTV video at distances up to 750ft (225m) when used
with a passive NVT transceiver or hub
• Up to 3,000 feet (1,000 m) with a DigitalEQ
TM
Hub or active receiver
• Up to 1,500 feet (460m) shall be supported by any NVT StubEQ
TM
Hub
• Supports pluggable screw terminal or RJ45 connections
• No power required
• Exceptional interference rejection
• Built-in transient protection
• Supports “up-the-coax” type control signal up to 750ft (225m)
• Compatible with qualified UTP cameras
• Two NV-413As may be rack mounted using the NV-RM8/10 Rack Panel Kit
• Limited lifetime warranty
The NVT Model NV-413A 4-channel Video Transceivers is a passive (non-amplified) device that allows
the transmission of real-time monochrome or color video over Unshielded Twisted-Pair (UTP) telephone
wire. Baseband (composite) signals of any type are supported.
“Up-the-coax” type signal may be sent over the same wire pair. Used as a receiver, the NV-413A is fully
compatible with qualified cameras that are equipped with an NVT twisted-pair output.
The unparalleled interference rejection and low emissions of the Model NV-413A allow video signals to
co-exist in the same wire bundle as telephone, datacom, or low-voltage power circuits. This allows the
use of a shared or existing cable plant. With built-in transient protection, damaging voltage spike prob-
lems are eliminated.
Model NV-413A
4-Channel Video Transceiver