P1453 3D Vision Pro Embedded Hub Manual Last Update: 5/22/12 Page 1 of 10
Table of Contents Getting to Know the P1453 _____________________________________________________________________ 3 System Requirements___________________________________________________________________________ 4 Installation Guide ______________________________________________________________________________ 5 Product Specicification_________________________________________________________________________ 8 Regulatory Compliance Statement ______________________________________________________ 9 Last Upda
Getting to Know the P1453 The following figure shows the appearance of the P1453. The actual product may differ. ① Mini PCI Express connector It is used to connect the P1453 to the WWAN Mini PCI Express interface of the PC. ② Screw holes They are used to fix the P1453 on the main board of the PC with screws. ③ Antenna interfaces They are used to connect antenna. Please note that only MAIN antenna (M) is used for RF connection, AUX antenna (A) is for mechanical retention only.
System Requirements Before you begin, please review the following minimum system requirements to ensure your Laptop meets the hardware requirements necessary to enjoy the 3D Vision experience.
Installation Guide 1. Installing the P1453 onto the Main Board of the PC Insert the Mini PCI Express connector of the P1453 into the WWAN Mini PCI Express interface on the main board of the PC. 2. Press downwards to fix the P1453 in the module slot. 3. Use a screwdriver to fix the P1453 onto the main board of the PC with two screws provided in the P1453 packing box.
4. Insert the connector of the main antenna into the MAIN antenna interface (M) of the P1453 according to the indication on the label of the P1453. Note: Insert the antenna connectors vertically into the antenna interfaces of the P1453. Do not pinch the antenna cable or damage the connectors. Otherwise, the wireless performance of the P1453 may be reduced or the P1453 cannot work normally.
3. Slide backwards the two clips to release the P1453 from the slot. Then, lift up the P1453. Installing the P1453 Software The driver of P1453 is included in NVIDIA graphics driver; you can down load the driver from http://www.nvidia.com/page/home.html 1, Double click the driver to run the program 2. Follow the prompts of the installation wizard. Uninstalling the Management Program 1. Choose Start >Control Panel 2.
Technical Specification: 1.1. 1.2. 1.3. 1.4. 1.5. 1.6. 1.7. 1.8. 1.9. 1.10. 1.11. 1.12. Power Input: DC 3.3V @140mA Transmission mode: RF Frequency: 2406~2473 MHz RF channel quantity: 68 Center of Channel: 2406MHz /2407MHz/2408M…2472MHz/2473MHZ Channel Interval: 1MHz Width of Channel: ≤1.0MHz Data Rate: <1Mbps Modulate mode: GFSK Effective distance: 25m Operating Temperature: 0℃~55℃ Antenna type: PIFA Table for Filed Antenna Ant. Brand Model Name/Part No.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
The final end product must be labeled in a visible area with the following: The Industry Canada certification label of a module shall be clearly visible at all times when installed in the host device, otherwise the host device must be labelled to display the Industry Canada certification number of the module, preceded by the words “Contains transmitter module”, or the word “Contains”, or similar wording expressing the same meaning, as follows: Contains transmitter module IC: 7361A-P1453, where 7361A-P1453 i
