Cut Sheet

WALL-MOUNT CABINETS AccesPlus Double-Hinge
nVent.com/HOFFMANSUBJECT TO CHANGE WITHOUT NOTICENETWORKING1
Spec-00534 M
ACCESSPLUS DOUBLE-HINGE, TYPE 1
INDUSTRY STANDARDS
UL 2416; Type 1; File No. E230874
cUL Listed per CSA C22.2 No. 182.4
EIA 310-D
NEMA/EEMAC Type 1
EIC 60529 IP20
Per BICSI TDMM Tenth edition, Chapter 7, Telecommunication
Enclosures (TE)
APPLICATION
AccessPlus Cabinets provide security, equipment access, cooling
and support for network and other 19-in. rack-mount equipment.
The cabinet has three components: front door, center section and
wall section.
FEATURES
•
Double-hinged for easy equipment access; center section
provides 19-in. rack mounting per EIA universal spacing and is
accessed through the front door or swing the center section away
from the wall section for rear access
•
Round corners; no sharp edges
•
Front door has either a solid steel or hardened, tinted safety-glass
window door for superior scratch resistance
•
Center section easily removed from rear section; tool-less one-
person installation possible
•
Self-grounding, plated steel rack angles fully adjustable within
center section
•
Wall section provides cable entry and cable management with
knockouts or gland plates
•
Glandplatemodelprovideseasyretrotandfastinstallationand
allows for pre-terminated cables or pre-wired patch panels; no
need to re-terminate and test
•
Self-locking center-to-wall section latches in two locations
•
Front access to all latches (no exposed side latches); cabinet can
be installed tightly in corners
•
Ventedsidesprovidecrossowventilationtoimproveheat
dissipation
•
Vertical cable manager included in 28-in.-wide models
•
A full line of accessories is available
•
One set of plated, self-grounding, tapped 10-32 rack angles per
EIA universal spacing standards, which can be adjusted front-
to-back, is provided with each center section of the cabinet;
additional tapped- or square-hole rack angles can be added to the
cabinet to provide additional mounting
SPECIFICATIONS
Front Door (window or solid steel)
• Composite frame (injection molded top and bottom with extruded
composite sides)
• 140-degree opening door
• Field-reversible (left or right) hinge
• Quarter-turn key lock, two keys included
• Window door is scratch-resistant 1/4-in. tinted safety glass
• Soliddoorhas16gaugesteelinsertwithmatchingblacknish
Center Section
• Welded 14 gauge steel
• Solid top of center sections provides protection against falling
debris
• Ventilated sides (to which fans can be added)
• Self-latching closure connects center section to wall section
• Self-alignment ramp supports center section to wall section
• Heavy duty center-to-rear section hinge with quick-release self-
retained hinge pin eases wall installation
Rack-Mounting Angles
• 12 gauge, plated steel
• EIA universal spaced 19-in. rack-mounting holes
• RU marked from bottom to top
• Tapped 10-32 holes, 20 mounting screws included
Rear Wall Section
• Welded 14 gauge steel
• Radius corners; no sharp edges
• Available with knockouts or gland plates
• Raised pads for accessory mounting
• Cable tie-down points for cable management
• Keyhole mounting holes allow wall section to be mounted over
fasteners and eases installation
• Three cable-entry grommets
FINISH
Pretreated steel coated with RAL 9005 black light-textured, low-
glosspolyesterpowderpaint.Othernishesavailable—contact
nVent HOFFMAN Customer Service.
Bulletin: DWDH1