Installation Guide

nuvoiron.com
•
1.866.955.0355
•
[e-mail]
#NuvoIron for a chance to be featured on our social media pages!
@
nuvoironfencing
@
nuvoiron
@
nuvoiron
@
nuvoiron
INSTALLATION INSTRUCTIONS
HDWPCP4B
4" x 4" Heavy Duty Wood Post Connector Plate
For securing and stabilizing a nominal wood 4" x 4" post to a wood surface.
DO NOT USE ON A STRUCTURE OVER 60" IN HEIGHT OR ON A DECK MORE THAN 24" OFF THE GROUND.
PARTS INCLUDED:
1. Measure your post and cut to the desired length.
Place your plate at the bottom of the post (with the raised side to the post)
and using Screw A, fasten the plate to the post to secure it while you
attach the larger fasteners.
2. Now that your plate is fastened, drill 1/8" pilot holes where
the four holes at the bottom are.
Attach the plate to the post using four (4) of Screw B.
Add the rubber washer to each screw before attaching it.
3. To begin surface installation, mark and drill 1/8" pilot holes.
Secure the plate to the surface using four (4) of Screw C.
Add a rubber washer to each screw before attaching it.
Ensure your screws are fully embedded into the
same thickness of material.
IMPORTANT:
Please Note: before building a permanent structure, it is important to take into consideration where you live and your typical exposure to the seasonal elements as product
performance may change accordingly. This includes, but is not limited to, rain, wind, snow, ice, sunlight, ooding, earthquakes and intense heat. Wearing personal
protective equipment; safety glasses, etc., and using suitable fasteners for your application are equally as important in ensuring your installation goes smoothly and safely.
Additionally, load calculations are unavailable. Prior to construction, check with your local municipality for building code requirements in your area (consulting local
building codes is required when supporting permanent structures).
For certain structures, we recommend consulting a professional to ensure that these products are appropriate for your intended application and that the structural
components for which these products are to be used in connection with are sound.
In no event shall Nuvo Iron
™
be liable for any consequential, special, or incidental changes arising out of breach of local, municipal, country, state, provincial, and federal
building codes or any other type of laws or bylaws. Furthermore, Nuvo Iron
™
shall not be held liable for any loss or damage resulting from improper use.
Nuvo Iron
™
, its advertising agency and delegates have made every effort to ensure the accuracy of all measurements and other details in these instructions and we
anticipate no problems to arise. However, we cannot be responsible for errors beyond that effort. Therefore, always double-check details before beginning your project.
Nuvo Iron
™
, its advertising agency and delegates shall not be held responsible for injury, damage or any other loss, however caused, resulting from the information
contained in these instructions.
SCREW A (1) SCREW B (4) SCREW C (4) RUBBER WASHERS (8)