*/4536$5*0/ .
8"3/*/( */530%6$5*0/ DANGER FIRE OR EXPLOSION HAZARD If you smell gas: • Shut off gas to the appliance. • Extinguish any open flame. • If odor continues, leave the area immediately. • After leaving the area, call your gas supplier or fire department. Failure to follow these instructions could result in fire or explosion, which could cause property damage, personal injury, or death.
SAFETY INFORMATION SAFETY INFORMATION Before you assemble or operate this unit, please carefully read this entire manual. Failure to do so WARNING • The installation of this unit must adhere to local codes or Propane Storage and Handling Code, CSA B149.2. • THIS UNIT IS INTENDED FOR OUTDOOR USE ONLY! This product shall be used outdoors, in a ventilated space and shall not be used in any enclosed area.
HARDWARE SAFETY INFORMATION Only use the regulator and hose assembly provided with this unit. Replacement parts must be supplied directly by us . Inspect the burner before use of this unit. If the burner shows any kind of damage, do not operate the appliance. For assistance with repair or replacement of the burner or any other parts, contact to us. NOTE: You must follow all steps to properly assemble this heating item. Make sure the gas valve is turned “OFF” before assembling.
ASSEMBLY INSTRUCTIONS CONTENTS E 1. Attach the panel (E) to the legs (G) using nut (CC) by wrench. B A F D Item Description Qty A Lid 1 B Table Top 1 C Door 1 D Panel 1 E Panel 1 F G Panel Leg 1 1 H Leg 1 I Metal Stand ProtectiveCover J K 3. washers (BB). ) using screws (AA) and 1 1 1 box M Glass Rocks Burner (preassembled) Firebowl (preassembled) N Guard (preassembled) O Control Knob (preassembled) 1 1 1 P Regulator Hose (preassembled) 1 L 2.
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS 7. Place propane gas tank (not included) into the metal stand (I). Make sure the gas tank sits on the metal stand (I) completely. Turn the preassembled wing screw on the outer part of metal stand (I) clockwise to secure the propane gas tank tightly. I 4. I I 8. Turn the cylinder valve on the tank clockwise to close the propane tank.
OPERATION Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor area. Connect the propane gas tank to the regulator and turn the valve on the unit to the “off” position. Brush a soap and water mixture on all connections. Turn the gas supply on; if bubbles occur on any connection there may be a leak. If you smell gas or a leak is discovered turn the gas valve off, disconnect propane gas tank and do not use the appliance until the leak is repaired.
TROUBLESHOOTING Problem Heating unit won’t light Cause Solution Igniter pin and burner are wet Dry off with a soft cloth Igniter battery is incorrectly inserted Check which direction the battery is inserted Contact us.