MODEL: S3GCOMP 3 GALLON OIL-FREE PANCAKE AIR COMPRESSOR S3GCOMP-V1 06/19
MODEL: S3GC0MP MODEL: S3GC0MP SYMBOLS GENERAL SAFETY INFORMATION PRE-OPERATION Specifications Duty Cycle Placement of Air Compressor Attaching the Hose OPERATION Preparing for Start-Up Starting the Compressor Checking the Safety Valve Running the Air Compressor 3 3-7 7-10 7 7 8 8 8-11 8-9 9 9-10 10 11 11-12 11 13 13-15 Draining the Tank MAINTENANCE General Maintenance CARE AND CLEANING TROUBLESHOOTING WARNING The warning and precautions discussed in this manual cannot cover all possible conditions and s
MODEL: S3GC0MP PERSONAL SAFETY (CONTINUED) rubber bumpers. Do not lift by the shroud. Operating any power tool can 3. When transporting the compressor in result in foreign objects being a vehicle, trailer, etc., Make sure the thrown into your eyes, which can tank is drained and the unit is result in severe eye damage. secured with straps to prevent Before beginning operation, always tipping.
MODEL: S3GC0MP ELECTRICAL SAFETY (CONTINUED) NOTICE: Use longer air hoses instead of long extension cords. Your air compressor ill run better and last longer. ELECTRICAL SAFETY (CONNECTION) WARNING: Check extension cords before each use. If damaged, replace immediately. Never use the air compressor with a damaged cord since touching the damaged area could cause electrical shock resulting in serious personal injury.
MODEL: S3GCOMP MODEL: S3GCOMP PLACEMENT OF AIR COMPRESSOR WARNING: If any parts are damaged or missing, do not operate until the parts are replaced. Failure to follow this warning could result in serious personal injury. Risk of bursting. Too much air pressure causes a hazardous risk of bursting. Check the manufactures maximum pressure rating for air tools and accessories. The regulator outlet pressure must never exceed the maximum pressure rating.
MODEL: S3GCOMP 1. Rotate the pressure regulator knob (C) to the desired pressure. Turning the knob clockwise (+) increases air 1. Set the ON/OFF Switch (A) to the ON pressure at the outlet; turning position and wait for the tank to fill. The counterclockwise (-) reduces air compressor automatically shuts off pressure at the outlet. when the pressure reaches the preset 2. If using an inflation accessory, maximum. control the amount of air flow with 2.
MODEL: S3GCOMP GENERAL MAINTENANCE (CONTINUED) 3. Inspect the tank annually for rust, pin holes, or other imperfections that could cause it to become unsafe. 4. Avoid using solvents when cleaning plastic parts. 5. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. 6. Use clean cloths to remove dirt, dust, oil, grease, etc. 7. Any service, other than general maintenance, should be performed by an authorized service representative.
MODEL: S3GCOMP PROBLEM POSSIBLE CAUSE The pressure switch is bad. The Compressor does not run. The motor hums while running slowly, or it doesn't run at all. CORRECTIVE ACTION Release the air from the tank until the compressor restarts automatically. There is low voltage from the power source. Call an electrician. The wrong gauge wire or length of extension cord is being used. Check for proper gauge wire and cord length. There is a shorted or open motor wiring.
