MODEL: S3GCOMP 3 GALLON OIL-FREE PANCAKE AIR COMPRESSOR S3GCOMP-V1 06/19
MODEL: S3GC0MP SYMBOLS GENERAL SAFETY INFORMATION PRE-OPERATION Specifications Duty Cycle Placement of Air Compressor Attaching the Hose OPERATION Preparing for Start-Up Starting the Compressor Checking the Safety Valve Running the Air Compressor 3 3-7 7-10 7 7 8 8 8-11 8-9 9 9-10 10 11 11-12 11 13 13-15 Draining the Tank MAINTENANCE General Maintenance CARE AND CLEANING TROUBLESHOOTING WARNING The warning and precautions discussed in this manual cannot cover all possible conditions and situations that m
MODEL: S3GC0MP PERSONAL SAFETY (CONTINUED) rubber bumpers. Do not lift by the shroud. Operating any power tool can 3. When transporting the compressor in result in foreign objects being a vehicle, trailer, etc., Make sure the thrown into your eyes, which can tank is drained and the unit is result in severe eye damage. secured with straps to prevent Before beginning operation, always tipping.
MODEL: S3GC0MP ELECTRICAL SAFETY (CONTINUED) Ampere rating (on air compressor data plate) Cord Length 0-2.0 2.1-3.4 3.5-5.0 5.1-7.0 7.1-12.0 12.1-16.0 Wire Size (A.W.G) 25ft. 16 16 16 16 14 14 50ft. 16 16 16 14 14 12 16 16 14 12 10 ~ 100ft. Used in 12-gauge - 20 amp circuit. WARNING: Check extension cords before each use. If damaged, replace immediately.
MODEL: S3GCOMP MODEL: S3GCOMP PLACEMENT OF AIR COMPRESSOR WARNING: If any parts are damaged or missing, do not operate until the parts are replaced. Failure to follow this warning could result in serious personal injury. CAUTION: Do not use in an environment that is dusty or otherwise contaminated. Using the air compressor in this type of environment may cause damage to the unit. 1. Place the air compressor in a clean, dry, and well-ventilated area. 2.
MODEL: S3GCOMP 1. Rotate the pressure regulator knob (C) to the desired pressure. Turning the knob clockwise (+) increases air 1. Set the ON/OFF Switch (A) to the ON pressure at the outlet; turning position and wait for the tank to fill. The counterclockwise (-) reduces air compressor automatically shuts off pressure at the outlet. when the pressure reaches the preset 2. If using an inflation accessory, maximum. control the amount of air flow with 2.
MODEL: S3GCOMP GENERAL MAINTENANCE (CONTINUED) CARE AND CLEANING WARNING: 3. Inspect the tank annually for rust, pin holes, or other imperfections that could cause it to become unsafe. 4. Avoid using solvents when cleaning plastic parts. Always release all pressure, disconnect from power supply, and allow unit to cool to the touch before cleaning or making repairs on the air compressor. 5. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use.
MODEL: S3GCOMP PROBLEM POSSIBLE CAUSE The pressure switch is bad. The Compressor does not run. The motor hums while running slowly, or it doesn't run at all. CORRECTIVE ACTION Release the air from the tank until the compressor restarts automatically. There is low voltage from the power source. Call an electrician. The wrong gauge wire or length of extension cord is being used. Check for proper gauge wire and cord length. There is a shorted or open motor wiring.