400 User’s guide «FCC » DECLARATION OF CONFORMITY FCC rules – PART 15 NUM’AXES declares that the training collar CANICOM 400 complies to all dispositions of the part 15 of the FCC rules This device complies with part 15 of the FCC. Operation is subject to the following conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received including interferences that may cause undesired operation.
WARNING Any person with individual device for cardiac assistance (pacemaker, defibrillator) must take precautions when they use CANICOM 400. These devices emit some static magnetic fields (a magnet is located in the remote control) (Frequency= 915 MHz, at = 0.75 mW). The device complies with Part 15 of the FCC rules. Any technical changes or modifications on the receiver collar or on the remote control not expressly approved by the manufacturer shall void the user’s authority to operate the equipment.
● Contents of the product CANICOM 400 Inside the ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ packaging you will find: 1 or 2 CANICOM receiver collar(s) equipped with short contact points 1 or 2 lithium 3 Volt CR2 battery(ies) for the collar(s) 1 CANICOM 400 remote control equipped with 1 lithium 3 Volt CR2 battery 1 neon test lamp 1 or 2 pair(s) of long contact points 1 carry strap 1 DVD this user’s guide ● Description of the product 2 contact points (short or long) On/Off indicator + indicator of radio reception + battery level i
- A beep sound (low pitch) is emitted, indicating the correct installation of the battery. If you do not hear any beep sound after inserting the battery, immediately remove it from its housing. Check the polarity before trying again. - Before putting the lid back in place, check that the rubber seal is in its groove. Make sure the tab is in correct position (inside the battery housing) to maintain water tightness.
Coding of the remote control and receiver collar(s) Each remote control has its individual radio operator code. The coding of the remote control with the receiver collar(s) enables to couple your remote control with the receiver collar(s) provided. IMPORTANT: before beginning the coding (first use of the receiver or re-coding), make sure no other person is using his CANICOM 400 or other products from the NUM'AXES range close by. Your receiver could accidentally record the code of his remote control.
If you press the “Beeper” button the receiver collar will emit sound signals. There is no time limit for this function: the beeper will continue to sound as long as you press the button. A “transmission” symbol will appear on the LCD screen of the remote control; the indicator light on the collar goes from flashing green to permanent green as long as you press the button. It is up to you to use the beeper depending on the way you want to train your dog.
Replace ▪ ▪ ▪ ▪ ▪ ▪ the battery(ies) as follows: On the back of the remote control, unscrew the screw and remove the battery cover. Remove the old battery(ies) using the special tab. Insert the new battery(ies) paying attention to follow polarity indicated on the battery housing. For CANICOM 400, a tab is under the battery. Put the lid back in place. For CANICOM 400, make sure the tab is in correct position (inside the battery housing) to maintain water tightness. Put the top back, using the screw.
The training instructions you give to your dog are sent from the remote control to the receiver collar(s) by radio waves. These radio waves are sensitive and the range reaches approximately 400 yards for the CANICOM 400 (depending on geography and environment). The performances of your CANICOM 400 will be optimal if you respect the following recommendations: ▪ To obtain a good radio range, do not cover the top of the remote control unit with any part of your hand while holding.
● Cautions for use ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ Before using CANICOM 400, we advise you to have your dog checked by your vet to ensure it is fit to wear a collar. The CANICOM receiver collar is totally waterproof. Your dog can swim in water. In order to maintain water tightness, we recommend the replacement of the seal located in the receiver collar every year. The CANICOM 400 remote control is showerproof only. It is only designed to remain a short time in the rain. Put it safe from water as soon as possible.
If you omit one of these items, the After Sales Service will have to invoice you for any repair costs incurred. ● Technical specifications CANICOM 400 CANICOM remote control receiver collar Power 1 3-V lithium battery CR2 1 3-V lithium battery CR2 Battery life Continuous use: In stand by: approximately 7 months approximately 30 000 triggers Continuous use: approximately 2 months Frequency (Power) 915 MHz (0.
▪ negligence or incorrect use (ex: bites, breakage, cracking), ▪ use contrary to the instructions or not envisioned therein, ▪ repairs performed by unauthorized persons. ▪ Loss or theft. If the product is found to be defective, NUM’AXES will either decide to repair or to replace it. No claim may be advanced against NUM’AXES, particularly in relation to incorrect use or breakdown of the product.
● Collection and recycling of your device at the end of its life The pictogram household refuse. which appears on your product means that this one can not be thrown with You have to bring the device to a collection location suitable for treatment, development, recycling of electric wastes or bring it back to your distributor. Adopting this process, you do something for the environment you contribute to the preservation of natural resources and the protection of human health. www.numaxes.