Installation Guide
TYPE SIX ASSEMBLY
Please Note:
• Review and abide by all building and plumbing codes
• Standard codes for Novao faucets: cUPC/CSA/AB1953
• Novao faucets need to be installed by a professional
TROUBLESHOOTING TIPS
SoluonIssue Reason
Check the shut-o valves, must be open
all the way; Blow out pipe/hoses
Shut-o valves not open all the
way; Debris or air pockets in pipes
Low Water Pressure/Flow
Blow out pipe/hoses; Might have to
replace the valve/cartridge
Dirt and debris collected in the
valve/cartridge
Leaking from under the handle
Ask your plumber to install an access
panel in case you need to get in there
Hot/cold lines connected
incorrectly
Need to access plumbing lines
Finish is changing color or is shiny
Abrasive cleaners, soaps or other
factors constantly in contact with it.
Stop using abrasives; Replace parts
Apply
thread
sealant or
plumber’s
tape
Cold
Hot
Rough-in Valve /
Concealed Body
Handle
Plate
Cover
Handle
Spout
200mm
Conceal
Body
Hot Water
Pipe
Cold Water
Pipe
Exposed Studs
w/ Wood Blocking
Finished Wall
Applicable for the following Wall-mount faucet series:
NBF-W02 NBF-W03 NBF-W04
• We recommend consulng a professional if you are unfamiliar with
installing wall mounted bathroom xtures and plumbing. For the
following installaon instrucons, it is assumed the water is turned o at
the source, old xtures have been removed, water supply lines have been
relocated to the proper installaon locaon, the wall studs are exposed
and your professional has installed wood blocking between the two studs
where the faucet will mount.*
* Important: Take into consideraon the thickness of your nished wall
materials. If the concealed body/valve is installed too far behind your nished wall,
you may be le with insucient clearance to aach the spout and handles.
• The installaon posion and height of the main body, can be determined
according to your own needs. Make sure you have enough area created
behind the wall in order to secure the rough-in valve. Use the dimensions
of the faucet for proper sizing of wall opening. You will have three open
areas: the main body conceal area, as well as the cold water and hot water
pipe areas.*
* Important: Remember, the higher you place the faucet the more dicult it
is to control where the water goes when turned on, and the more likely it is to splash.
Too low and you’re banging your hands against the sink.
• Remove the spout and rotate handle plate to remove handle secons
from the valve.
• Mount the rough-in valve into its prepared locaon in the wall, water
inlets poinng down. Aach the valve body to the wood blocking using
*galvanized pipe clamps (*NOT provided). Use a level to ensure that the
valve is mounted straight. Connect *main water lines (*NOT provided) to
the valve. Apply thread sealant or plumber’s tape to the threaded
connecon to ensure a waterght seal.
Steps to Complete Your Faucet InstallSteps to Complete Your Faucet Install
• In most cases, there is no need to dissemble handle plate,
cover or handle before aaching to body
• Make sure no silt or debris is in water pipes prior to install