Nova Electronics (Shanghai) Co., LTD File No:R-JS-AS-13 Version:V1.0 NOVA77GB-C Pro 77GHz Millimeter-Wave Radar User Manual Prepared by Itachi.Wang 2021.6.17 Checked by Mack.Zhong 2021.6.18 Approved by Kevin.Li 2021.6.
Nova Electronics (Shanghai) Co., LTD File No:R-JS-AS-13 Version:V1.0 Version history Version V1.0 Modify the description Documentation initial release Modified by Data Itachi.Wang 2021.6.
Nova Electronics (Shanghai) Co., LTD File No:R-JS-AS-13 Version:V1.0 Contents 1 overview ..............................................................................................................................................................1 2 Mechanical and interface definitions ....................................................................................................... 1 2.1 Product picture ...............................................................................................
Nova Electronics (Shanghai) Co., LTD 1 File No:R-JS-AS-13 Version:V1.0 overview When driving a vehicle equipped with NOVA77GB-C Pro Lane Change Assist System to change lanes, the system can issue corresponding warnings to avoid accidents. The system complements the view of the mirrors inside and outside the car, and is not intended to completely replace the mirrors.
Nova Electronics (Shanghai) Co., LTD File No:R-JS-AS-13 Version:V1.0 Table 1 connector pin definition functional PIN No.
Nova Electronics (Shanghai) Co., LTD File No:R-JS-AS-13 Version:V1.0 Figure 3 Radar installation height diagram 3.1.2 Installation angle NOVA corner radar should be installed at both ends of the vehicle side and rear. Figure 4 below is a schematic diagram of the two-dimensional installation horizontal angle. Figure 5 below is a schematic diagram of the installation pitch angle.
Nova Electronics (Shanghai) Co., LTD File No:R-JS-AS-13 Version:V1.0 Figure 5 Installation pitch angle diagram 3.1.3 Installation error The installation error of NOVA corner radar must meet the requirements of the following table to ensure the accuracy of radar detection angle and make the radar work normally. When calibrating the radar installation angle, the vehicle must stay on a horizontal plane to avoid tilting the body.
Nova Electronics (Shanghai) Co., LTD 3.2.2 File No:R-JS-AS-13 Version:V1.0 Bumper Material Requirements There should be no obstructions (including bumpers) in front of the radar. If the obstructions or bumpers are unavoidable, the materials of the obstructions must have a small dielectric constant and dielectric loss. These materials include Polypropylene, Polyamide, Polycarbonate, ABS (Acrylnitril-Butadien-Styrol), PC-PBT (Polycarbonate Type), etc.
Nova Electronics (Shanghai) Co., LTD File No:R-JS-AS-13 Version:V1.0 In order to prevent the radar beam from being distorted, the bumper should be kept as flat as possible, and the thickness should be uniform,any slight bend can have a big impact on the radar beam. 3.2.
This equipment complies with FCC/IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. ce matériel est conforme aux limites de dose d'exposition aux rayonnements, FCC / CNR-102 énoncée dans un autre environnement.cette eqipment devrait être installé et exploité avec distance minimale de 20 entre le radiateur et votre corps. § 95.