MAXIMUM LOAD 88lbs (40kg) NORTHWEST ELECTRIC FIREPLACE MANTEL WITH REMOTE CONTROL OWNER’S MANUAL + FOR RESIDENTIAL USE ONLY spo WARRANTY VOID OUTSIDE
Care and Maintenance Safety Information WARNING: Always disconnect from the power supply bettors A cleaning the heater, First tum off the main power. Then remove. the electrical pig from the wale outlet. WARNING: Do nit use this replace Insert {f any part of 1t has @ ‘been under water. Immediately call 2 qualified service technician to Inspect fhe firebox and replace sy part of the electrical system which has been under water.
Safety Information(continued) | Using the Remote Control GROUNDING INSTRUCTIONS 1. Installing the battery ¥ & The battery is supplied with the remote control. The first thing to do with the remote control is to remove the plastic sheet insulated the CANER: Improper concierge o 11 immanent ek battery. For replacement battery, use lithium-based CR2025 battery. Pleads follow the sequence below o placers the battery.
Operation (continued) Assembly 7. Using the flame control 1. Attaching the metal trims O Press the flame button{5) to set the flames for different levels of flame height. These flame levels are shown in the display(1}. The o Fasten the top trim (4 1o the top of the fireplace insert (W) with two screws (18). Make sure that the right angle side points towards the front . . of the unit.
Operation Operation (continued) 3. Identifying the control panel 5. Using the timer function o The control panel is located on the front right corner of the fireplace/heater unit. O The timer button(3) allows you to set the amount of time you want the fireplace/heater to run. The timer button(3) operates both the flames and the heater function. If the heater is operating when the timer is set, then the heater is on the timer.