User's Manual

Wireless Keyfob SKF2

The SKF2 is a Wireless Keyfob (Keychain Remote) with Stay and Away arming modes as well as panic

emergency mode. The Keyfob includes a status LED to indicate the current status of the system. The

status LED will only operate while in use (i.e. while pressing keys and for 20 seconds thereafter).

Programming

Your LifeShield system can support up to [4] Keyfobs in a single system. Each Keyfob must be registered

into the system before use. The Keyfob shipped with your Security Base was pre-registered before

shipment. Additional Keyfobs may be registered by using your Security Tablet, LifeShield web portal, or

LifeShield mobile application (collectively “apps”). To register a Keyfob, enter the Settings tab of the

respective apps, and select Add Device. Follow the on-screen prompts. When prompted, press the Stay,

Away, and * keys simultaneously on the Keyfob for 2 seconds. The Base will respond with audio

confirmation and the apps will show a success message. If the Keyfob fails to register with the Base, the

apps will show a failure message. Possible causes of registration failure include: Keyfob not powered,

wrong keys pressed, Keyfob out of range with Base, or too many Keyfobs already registered in LifeShield

System.

Using the Keyfob

The Keyfob must be used within good communications range of the Security Base. While range varies

with house construction, it is generally sufficient if the Keyfob is within 30 to 50 feet of the Base.

PAGE 1
Wireless Keyfob SKF2 The SKF2 is a Wireless Keyfob (Keychain Remote) with Stay and Away arming modes as well as panic emergency mode. The Keyfob includes a status LED to indicate the current status of the system. The status LED will only operate while in use (i.e. while pressing keys and for 20 seconds thereafter). Programming Your LifeShield system can support up to [4] Keyfobs in a single system. Each Keyfob must be registered into the system before use.
PAGE 2
The Keyfob will sleep within 30 seconds after the last key has been pressed. The next time you press a key, the Keyfob must obtain system status from the Security Base. This status update may take 2 to 5 seconds to receive, and then the LED will show current LifeShield system status. After you send a command to the Security Base, the Keyfob must obtain new system status. This will again take 2 to 5 seconds, and then the LED will update to the new status.
PAGE 3
FCC Part 15 This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.