User Instructions

ManualsBrandsNortek Security & Control ManualsElectronicsWireless glass break detector

DETECTOR TESTING

1. Follow the system’s

instructions to select Test

Mode. When instructed,

press button on Detector

(A) three times.

SPECIFICATIONS

Operating Temperature: 32° to 120° F (0° to 49° C)

Operating Relative Humidity: 5 to 95%, non-condensing

Operating Frequency: 908.42 MHz

Sensor Type: Single microphone, dual-stage

Glass Thickness: 1/8” (3.2 mm) to 1/4” (6.4 mm)

HELPFUL TIPS

• The minimum size for all glass types is 11” x 11”

(28 cm x 28 cm) square. Glass must be framed, in

a wall of the room or mounted in a barrier of 36” (91

cm) minimum width.

• The Detector will not lock onto the Mounting Plate

unless both CR123A batteries are installed.

• The Detector sends Z-Wave

signals to the system.

Z-Wave

is a registered trademark of Sigma

Designs Inc. and/or its subsidiaries.

WARRANTY

Lowe’s Utilitech Warranty Here??

REGULATORY NOTICE

Changes or modiﬁ cations to the device may void FCC compliance.

Les modiﬁ cations apportées à l’appareil peuvent annuler la

conformité Industrie Canada

PARING INSTRUCTIONS

1. Install two Batteries (CC) into

the Detector (A). Observe

polarity!

2. Bring detector within 10 feet

of the system. Set system

to add glass break detector

device, when instructed,

press the button on Detector

(A) three times to pair with the

system.

MOUNTING THE DETECTOR

1. Choose a location on the

ceiling or on an adjacent or

opposite wall within 12 feet

of the glass to be monitored.

Use the Mounting Plate (B) as

a template to mark the three

mounting holes.

2. Drill three 3/16” pilot holes

and insert Screw Anchors

(BB). Attach Mounting Plate

(B) with three Mounting

Screws (AA).

3. Match alignment marks on

Detector (A) and Mounting

Plate (B). Turn Detector

(A) clockwise to lock onto

Mounting Plate (B).

ITEM #0000000

MODEL #GB00Z-1

GLASS BREAK DETECTOR

Questions?

Call customer service at 1-000-000-0000,

5:00 a.m. - 4:30 p.m., PST, Monday-Friday

PACKAGE CONTENTS

HARDWARE CONTENTS

Note: Hardware shown actual size.

SAFETY INFORMATION

Please read and understand this entire manual before

attempting to assemble, operate, or install the product.

WARNING

Danger of explosion if batteries are installed

incorrectly. Replace only with the same or equivalent

type recommended by the manufacturer.

PREPARATION

Before beginning installation of product, make sure

all parts are present. Compare parts with package

contents list and hardware contents list. If any part

is missing or damaged, do not attempt to assemble,

install or operate the product.

Estimated Installation Time: 15 minutes.

Tools required for installation (not included):

Pencil, Phillips screwdriver, drill, 3/16” drill bit

x 1

Mounting Plate

x 3

Mounting Screw

x 3

Screw Anchor

x 2

CR123A Battery

x 1

Detector

AA CC

xxxxx

Printed in China

PRINTER’S INSTRUCTIONS:

INSTR,INSTL,GLASS BREAK,ZW - P/N: 235512 X11 - INK: BLACK - MATERIAL: 20 LB. MEAD BOND - SIZE: 11.000” X 8.500” - FOLDING: Z-FOLD, FINISH WITH LOGO SHOWING - SCALE: 1-1

235512 X11

Utilitech & UT Design

is a registered