User's Manual

2GIG-SMKE1-345
WIRELESS
PHOTOELECTRIC
SMOKE
ALARM
Installation
Instructions
PRODUCT DESCRIPTION
The 2GIG-SMKE1-345 is a photoelectric smoke alarm with a built-in
transmitter designed for use with the 2GIG-CNTRL-345 security system.
When smoke is detected, the alarm sounds a loud local alarm. Twenty
seconds after the local alarm sounds, the built-in transmitter sends a
digitally coded wireless signal to the Control Panel. The wireless signal
will be repeated every 20 seconds as long as smoke is still present.
The 2GIG-SMKE1-345 detector can send four different signals: alarm,
test, low battery, and status.
The Control Panel must be programmed to the detector’s serial
number before system testing and operation. Refer to the Control
Panel’s instructions for details on programming.
The detector is powered by a 3-volt lithium battery. The battery is supplied
with the detector and can power the unit for up to fi ve years. If the battery
voltage drops below a preset level the alarm will sound low battery beeps
and a low battery signal will be sent to the Control Panel.
Every hour, the detector will send a status transmission to the Control
Panel. The hourly signal updates the Control Panel with the detector’s
condition. By monitoring status transmissions, the Control Panel can
determine that the detector is still present in the installation and if it has
a low battery.
Maintenance: Occasionally clean the outside casing with a cloth. Ensure
that the holes on the front of the alarm are not blocked with dirt and dust.
Do not paint, and do not use cleaning agents, bleach, or polish on
the detector.
REMOVE PROTECTIVE COVER
REMOVE MOUNTING PLATE REMOVE BATTERY TAB CHOOSE ALARM LOCATION
INSTALL MOUNTING PLATE PROGRAM CONTROL PANEL MOUNT ALARM ON PLATE
Technical Support
866-670-1591
www.2gig.com
REMOVE
PROTECTIVE
COVER AND
DISCARD
TWIST MOUNTING
PLATE TO UNLOCK
REMOVE
MOUNTING
PLATE
PULL TO CONNECT
BATTERIES
REMOVE
BATTERY TAB
TO APPLY
POWER
3-VOLT LITHIUM BATTERY
TYPES: DURACELL DL123A,
PANASONIC CR123A,
SANYO CR123A, ADEMCO 466
SCREW
ANCHORS
FOR WALLBOARD
PLASTIC
SINGLE-GANG
ELECTRICAL BOX
OR
PRESS AND RELEASE
TEST BUTTON TO
SEND SIGNAL
REFER TO CONTROL PANEL'S INSTRUCTIONS TO
PREPARE RECEIVER TO ACCEPT THE DETECTOR'S
SERIAL NUMBER
A TEST SIGNAL
WILL BE SENT
AS SOON AS THE
SWITCH IS RELEASED
CONTROL PANEL
DETECTOR
TWIST SMOKE
ALARM CLOCKWISE
TO LOCK ONTO
MOUNTING PLATE
MATCH ALIGNMENT TABS IN
PLATE WITH TABS IN COVER
PRINTERS INSTRUCTIONS
INSTR,INSTL,2GIG-SMKE1-345 - P/N: 229910 X3 - INK: BLACK - MATERIAL: 20 LB. MEAD BOND - SIZE: 8.500” X 11.000” - SCALE: 1-1 - SIDE 1 of 2
I
R
L
I
S
T
D
CM