Install Manual

SAR8370-3
Pipe Cover
Installation Manual
Included Accessories
Check for any missing items before starting installation.
Installation
Refer to the illustration below for installing the pipe covers.
Make a hole (bottom diameter: 0.3"
(7.2mm), depth: 1.4"-1.6"(35-40mm))
using a drill at the screw hole position
on the wall. Then, hammer in the wall
anchor 10 and fix using the phillips
head screw 9 .
When fixing to the wall, the
part can be slid 0.4" (10mm)
to the rear by loosening the
tapping screw with PW 8 .
H32-K PC-084M
H39-K PC-063S-069M
H33-K PC-1S
H53-K PC-2S(-GRY)
H54-K PC-3S(-SUS)
H20-K PC-4S(-SUS)
H58-K PC-5S(-GRY)
*If tabs are not present, the installation can still be
completed after securing the pipe cover top 3 to the
rest of the pipe cover. For additional support, make
sure to use the provided philips head screws 9 and
wall anchors 10 to secure the cover to the wall.
Unit
The shape may differ
depending on the unit.
2
1
9
4
5
1
6
3
7
8
10
Be sure
to do
When tightening (or loosening) the panel screw,
be aware of the section without thread (as
illustrated below), and continue turning until
secured (or removed).
<When mounting> Turn horizontally while
pressing the panel screw in.
<When removing> Turn horizontally while
pulling the panel screw out.
When removing
When mounting
Screw retaining disc
Panel screw
of the front cover to the bottom
front section of the case.
Securely close the front cover
and tighten screws so that
it does not move.
Warning
Requests to Installers
Read this installation
manual carefully, and follow
the installation instructions.
traPtraP .oN traP.oN traP
1
1
1
1
1
yt'Qyt'Q
Side cover (left/right)
1 each
Pipe front cover
Pipe cover top
Pipe cover bottom front
Pipe cover bottom rear
2
2
6
2
2
Panel screw
Truss screw small
Tapping screw with PW
Phillips head screw
Wall anchor
2
3
4
5
6
7
8
9
10
*SAR8370 C*
PC-2S-GRY and PC-5S-GRY only
When removing
When mounting
Securely fit the lower section
Securely fix using panel screws.
Screw retaining disc
panel screw