CVK-SNRK Install Manual

ManualsBrandsNoritz ManualsAccessoriesNoritz Concentric Horizontal Snorkel Termination Kit

-1-

N-Vent SYSTEM (concentric) INSTALLATION INSTRUCTION

Snorkel Kit Installation

Failure to follow the installation instructions could cause FIRE, CARBON MONOXIDE

POISONING, or DEATH.

󳜪The edges of sheet metal parts may be sharp. Always wear gloves and appropriate eye,

foot, and other protections when handling these products.

󳜪It is recommended that experienced professionals familiar with the operation and

maintenance of gas burning appliances and vent/air intake system install this system.

These instructions are a guide to assist a professional installer.

󳜪Before commencing installation, please read the installation instructions carefully.

󳜪Failure to follow the installation instructions could cause not only the lower performance

of appliance but also property damage or personal injury.

󳜪This vent system is a special stainless steel vent system for gas burning appliances,

Category,Ⅱ,Ⅲ,Ⅳ.

󳜪Different Manufacturers have Different Joint Systems and Adhesives. Do Not Mix Pipe,

Fittings, or Joining Methods from Different Manufacturers.

󳜪Examine all components for possible shipping damage prior to installation.

Fig.1 Included Accessories

Fig.2 Outline of vent installation Fig.3 Dimensions of case

warning

warning warning

warning

caution

cautioncaution

caution

Summary of content (4 pages)

PAGE 1
N-Vent SYSTEM (concentric) INSTALLATION INSTRUCTION Snorkel Kit Installation ! Failure to follow the installation instructions could cause FIRE, CARBON MONOXIDE POISONING, or DEATH. warning The edges of sheet metal parts may be sharp. Always wear gloves and appropriate eye, foot, and other protections when handling these products.
PAGE 2
Fig.4 Adjustable range of vertical and horizontal distance *: The hatch area: in case using vent included in Kit as A or B Other area: in case replacing vent included in Kit to other vent a : The vertical distance between the center of CVT-SNRK-90ELB and the center of the horizontal vent b : the vertical clearance between CVT-SNRK-90ELB and ground when the clearance between the hole and ground is 3inch,.which should be set to 3inch or more.
PAGE 3
Fasten vent on the wall with SS5-3ADJ as shown on the left. The clearance between the vent and the indoor wall can be adjusted from 2.0 to 2.7inch. Attach CVT-SNRK-90ELB vertical vent. to the Properly seal any gaps with appropriate sealant. It can not be sealed when the case is mounted on the wall. Attach CVK-SNRK-C2 on the outdoor wall by 2 screws provided, adjusting the center of the case to the center of the vent. Maintain clearance from case and ground.
PAGE 4
Insert CVT-SNRK-90ELB into the 5” diameter hole of upper part of CVK-SNRK-C1. Install with the proper length protruding through the case. Fasten CVK-SNRK-C1 and C2 with 6 or 8 screws provided. Keep the distance between screws nearly equal so that they are fixed firmly. Properly seal between Case and the outdoor wall. Do not seal slit (drain) at the bottom of CVK-SNRK-C2. Use packing to seal when installed on a not flat wall.