WIRELESS MODULE User Guide
IMPORTANT! FOR OPTIMAL PERFORMANCE, BE SURE THAT THE EZ WANDER AND THE DETECTOR ARE ON THE SAME SIDE! Pairing Instructions for Anfibio and Kruzer 1. MAKE SURE YOUR DETECTOR IS OFF! 2. Insert your wired headphone's plug into the headphone jack located on the side of the EZ Wander. 3. Press and hold down the power button on the EZ Wander for about 7 seconds. The blue LED will flash fast while the button is pressed down.
Pairing Instructions for Invenio 1. MAKE SURE YOUR DETECTOR IS OFF! 2. Insert your wired headphone's plug into the headphone jack located on the side of the EZ Wander. 3. Press and hold down the power button on the EZ Wander for about 7 seconds. The blue LED will flash fast while the button is pressed down. Do not let go of the button until the beep indicating the battery status is heard through the headphones and the red LED on the EZ Wander lights up.
Pairing Instructions for TMD-101 1. MAKE SURE YOUR DETECTOR IS OFF! 2. Insert your wired headphone's plug into the headphone jack located on the side of the EZ Wander. 3. Press and hold down the power button on the EZ Wander for about 7 seconds. The blue LED will flash fast while the button is pressed down. Do not let go of the button until the beep indicating the battery status is heard through the headphones and the red LED on the EZ Wander lights up.
Pairing Instructions for PulseDive 1. MAKE SURE THE PULSEDIVE IS OFF! 2. Insert your wired headphone's plug into the headphone jack located on the side of the EZ Wander. 3. Press and hold down the power button on the EZ Wander for about 7 seconds. The blue LED will flash fast while the button is pressed down. Do not let go of the button until the beep indicating the battery status is heard through the headphones and the red LED on the EZ Wander lights up.
Pairing Instructions for Other Models RACER 2: SYSTEM BOX SERIAL NUMBERS BIGGER THAN 9402 GOLD RACER: SYSTEM BOX SERIAL NUMBERS BIGGER THAN 6916 IMPACT: Software version R2_V1.16_V1.14 or later versions. You can download the latest software version from the Software Update tab at the link below: https://www.noktadetectors.com/metal-detector/impact/ IMPORTANT! An ''off'’ position has been added to the wireless channels of your detector (shown with ‘’oF’’ on the screen).
. If the pairing is not successful or if you experience any distortion in the audio or interference from another detector, change the channel by pushing and holding the trigger switch forward on Racer 2 and Gold Racer while pressing the down button simultaneously and on the Impact, by pulling and holding the trigger switch while pressing the down button simultaneously. Each time you press the down button, channels will change between 00-09-oF. 8.
FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment。 Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
www.noktadetectors.