Nokia Bluetooth Stereo Headset BH-604 User Guide 9203660 Issue 2 EN
DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this HS-96W product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/ declaration_of_conformity/. © 2007 Nokia. All rights reserved. Reproduction, transfer, distribution or storage of part or all of the contents in this document in any form without the prior written permission of Nokia is prohibited.
Contents 1. Introduction ......................... 4 Bluetooth wireless technology .......... 4 Disconnect the headset.................... 9 Reconnect the headset..................... 9 2. Get started............................ 6 3. Basic use ............................. 10 Overview .................................................. Chargers ................................................... Charge the battery ................................ Switch the headset on or off ............. Switch on .....
Introduction 1. Introduction With the Nokia Bluetooth Stereo Headset BH-604 you can listen to music from your compatible music player and make and receive hands-free calls using your mobile phone. The music player can be the music player feature of your mobile phone or a separate music device. You can use the headset with compatible devices that support Bluetooth wireless technology. Read this user guide carefully before using the headset.
Introduction There may be restrictions on using Bluetooth technology in some locations. Check with your local authorities or service provider.
Get started 2. Get started ■ Overview The headset contains the following parts: • Fast forward key (1) • Microphone (2) • Volume key (3) • Multifunction key (4) • Play/pause key (5) • Rewind key (6) • Indicator light (7) • Charger connector (8) Before you can start using the headset, you must charge the battery and pair the headset with a compatible mobile phone. Parts of the headset are magnetic. Metallic materials may be attracted to the headset.
Get started 1. Connect the charger to a wall outlet. 2. Connect the charger cable to the charger connector. The indicator light is red while charging. It may take a while before charging starts. If charging does not start, disconnect the charger, plug it in again, and retry. Charging the battery fully takes less than 1 hour and 15 minutes. 3. When the battery is fully charged, the indicator light turns green. Disconnect the charger from the headset and the wall outlet.
Get started ■ Pair and connect the headset Pair and connect the headset with a mobile phone that has a music player feature If your phone supports the A2DP Bluetooth profile and has a music player feature, you can use the phone to make and receive calls and to play music with the headset. 1. Ensure that your phone is switched on. 2. If the headset has not been previously paired with a device, switch on the headset. The headset enters the pairing mode, and the indicator light starts to flash blue quickly.
Get started To pair the headset with a music player, follow the instructions in “Pair and connect the headset with a mobile phone that has a music player feature,” p. 8. If your music player does not have a keypad, it may use the Bluetooth passcode 0000 by default. If this is not the case, see the user guide of your music player to change the default Bluetooth passcode to 0000.
Basic use 3. Basic use ■ Place the headset over the head Place the headset over your head so that the speaker pads rest comfortably on your ears. Place the pad indicated with L on the left ear and the pad with R on the right ear. Adjust the headband length for the best fit. Warning: When using the headset your ability to hear outside sounds may be affected. Do not use the headset where it can endanger your safety.
Basic use To switch the call from the headset to a connected phone, press and hold the play/pause key for about 2 seconds. To switch the call back to the headset, press the multifunction key once. ■ Listen to music To listen to music, connect the headset to a compatible music player such as a mobile phone with a music player feature or other music device. The music player must support the A2DP Bluetooth profile.
Battery information 4. Battery information Your device is powered by a rechargeable battery. The battery can be charged and discharged hundreds of times, but it will eventually wear out. Recharge your battery only with Nokia approved chargers designated for this device. Unplug the charger from the electrical plug and the device when not in use. Do not leave a fully charged battery connected to a charger, since overcharging may shorten its lifetime.
Care and maintenance Care and maintenance Your device is a product of superior design and craftsmanship and should be treated with care. The following suggestions will help you protect your warranty coverage. • Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. If your device does get wet, allow it to dry completely. • Do not use or store the device in dusty, dirty areas.
Care and maintenance or your local Nokia representative. For more information, see product Eco-Declaration or country-specific information at www.nokia.com.
