Nokia Bluetooth Headset BH-904 9 1 3 4 5 2 6 10 7 8 9
11 12 14 13 15
ENGLISH DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this HS-101W product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/ declaration_of_conformity/. © 2009 Nokia. All rights reserved. Nokia, Nokia Connecting People and the Nokia Original Accessories logo are trademarks or registered trademarks of Nokia Corporation.
ENGLISH Introduction With the Nokia Bluetooth Headset BH-904, you can make and answer calls hands-free with your compatible mobile device. The headset is provided with a sliding boom that allows you to talk at a lower volume or in a noisy environment. Noise cancellation helps you handle calls in noisy environments. Read this user guide carefully before using the headset. Also, read the user guide for the device that you connect to the headset. This product may contain small parts.
ENGLISH Get started The headset contains the following parts shown on the title page: volume key (1), sliding boom (2), earpiece (3), indicator light (4), power key (5), charger connector (6), mute key (7), answer/end key (8), and microphones (9). Before using the headset, you must charge the battery and pair the headset with a compatible device. Warning: Use only chargers approved by Nokia for use with this particular model.
ENGLISH the AC-6 charger for 15 minutes provides up to 5 hours of talk time. 3. When the battery is fully charged, the green indicator light is displayed. Disconnect the charger from the headset, then from the wall outlet. Push the cover over the charger connector. To charge the headset with a compatible Nokia charger that has a 2.0 or 3.5 mm charger plug, use the Nokia Charger Adapter CA-146C (sold separately).
ENGLISH To switch off, press and hold the power key for about 2 seconds. The headset beeps, and the red indicator light is briefly displayed. If the headset is not connected to a device within 30 minutes, it switches off automatically. Pair and connect the headset Before using the headset, you must pair and connect it to a compatible device. You can pair the headset with up to eight devices, but you can connect it to only up to two devices at a time. 1.
ENGLISH To manually connect the headset to one or two last used devices, press and hold the answer/end key for about 2 seconds (when no devices are connected), or make the connection in the Bluetooth menu of the desired device. If you have a device connected to the headset and want to connect a second device, make the connection in the Bluetooth menu of the device. You may be able to set your device so that the headset connects to it automatically.
ENGLISH call is in progress, press the answer/ end key twice. To activate voice dialling (if your mobile device supports this feature with the headset), when no call is in progress, press and hold the answer/ Adjust volume end key for about 2 seconds. Proceed The headset automatically adjusts the as described in the user guide of the volume according to ambient noise. To mobile device. manually adjust the volume, slide the To answer a call, pull the boom volume key up or down.
ENGLISH When you mute or unmute the microphone, the headset beeps twice. To switch a call between the headset and a compatible connected device, press and hold the answer/end key for about 2 seconds. Allow connection to two devices You can have the headset connected to two devices at the same time. By default, the headset can only be connected to one device at a time.
ENGLISH Troubleshooting If you cannot connect the headset to your compatible device, check that the headset is charged, switched on, and paired with the device. Battery and charger information This device has an internal, nonremovable, rechargeable battery. Do not attempt to remove the battery from the device as you may damage the device. This device is intended for use when supplied with power from the following chargers: AC-6 and DC-6.
ENGLISH temporarily. Battery performance is particularly limited in temperatures well below freezing. Do not dispose of batteries in a fire as they may explode. Dispose of batteries according to local regulations. Please recycle when possible. Do not dispose as household waste. Never use any charger that is damaged. Operating times are estimates only.
ENGLISH • Do not drop, knock, or shake the device. Rough handling can break internal circuit boards and fine mechanics. • Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device. Only use a soft, clean, dry cloth to clean the surface of the device. • Do not paint the device. Paint can clog the moving parts and prevent proper operation. These suggestions apply equally to your device, charger, or any accessory.