Nokia Bluetooth Headset BH-208 6 7 8 5 3 10 11 12 9 9200858/1
ENGLISH DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this HS-80W product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/phones/ declaration_of_conformity/. 0434 © 2007 Nokia. All rights reserved.
ENGLISH countries. Diversion contrary to law is prohibited. Introduction The Nokia Bluetooth Headset BH-208 allows you to make and receive calls while on the move. You can use the headset with compatible phones that support Bluetooth wireless technology. Read this user guide carefully before using the headset. Also read the user guide for your phone, which provides important safety and maintenance information. Keep the headset out of reach of small children.
ENGLISH Get started The headset contains the following parts shown on the title page: indicator light (1), answer/end key (2), charger connector (3), earloop (4), microphone (5), earpiece (6), power key (7), and volume key (8). Before using the headset, you must charge the battery and pair the headset with a compatible phone. Warning: Use only chargers approved by Nokia for use with this particular enhancement. The use of any other types may invalidate any approval or warranty and may be dangerous.
ENGLISH starts. If charging does not start, disconnect the charger, plug it in again, and retry. Charging the battery fully may take up to 1 hour and 30 minutes. 3. When the battery is fully charged, the indicator light turns to green. Disconnect the charger from the headset and the wall outlet. The fully charged battery has power for up to 6 hours and 30 minutes of talk-time or up to 150 hours of standby time.
ENGLISH need to make the connection separately after pairing. You only need to pair the headset with your phone once. If the pairing is successful, the headset beeps and appears in the phone menu where you can view the currently paired Bluetooth devices. The headset is now ready for use. Basic use Place the headset on the ear Slide the earloop behind your ear (9), and point the headset toward your mouth. Carefully bend the earloop around your ear for the best fit (10).
ENGLISH To switch the call between the headset and a compatible phone, press and hold the answer/end key. Clear settings or reset To clear all the pairing settings from the headset, switch off the headset, and press and hold the power key and the answer/end key until the red and green indicator lights start to alternate. To reset the headset if it stops functioning, although it is charged, plug the headset into a charger, and press the power key and the answer/ end key at the same time.
ENGLISH Do not dispose of batteries in a fire as they may explode. Batteries may also explode if damaged. Care and maintenance Your device is a product of superior design and craftsmanship and should be treated with care. The following suggestions will help you protect your warranty coverage. • Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. If your device does get wet, allow it to dry completely.
ENGLISH All of the above suggestions apply equally to your device, battery, charger, or any enhancement. If any device is not working properly, take it to the nearest authorized service facility for service. Disposal The crossed-out wheeled-bin symbol on your product, literature, or packaging reminds you that in the European Union all electrical and electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life.