Nokia Bluetooth Headset BH-213 1 4 3 5 2 6 7 9 11 8 10 Issue 1
DECLARATION OF CONFORMITY Hereby, NOKIA CORPORATION declares that this HS-127W product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at http://www.nokia.com/ phones/declaration_of_conformity/. © 2008 Nokia. All rights reserved. Nokia, Nokia Connecting People and the Nokia Original Accessories logo are registered trademarks of Nokia Corporation.
Export controls This device may contain commodities, technology or software subject to export laws and regulations from the US and other countries. Diversion contrary to law is prohibited. Introduction With the Nokia Bluetooth Headset BH-213, you can make and receive calls while on the move. Read this user guide carefully before using the headset. Also, read the user guide for your phone. It provides important safety and maintenance information. This product may contain small parts.
Get started The headset contains the following parts shown on the title page: indicator light (1), multifunction key (2), charger connector (3), earloop (4), earpiece (5), volume key (6), and microphone (7). Before using the headset, you must charge the battery and pair the headset with a compatible phone. Parts of the device are magnetic. Metallic materials may be attracted to the device.
charging. Charging the battery fully may take up to 2 hours. 3. When the battery is fully charged, the green indicator light is displayed. Disconnect the charger from the headset, then the wall outlet. The fully charged battery has power for up to 10 hours of talk time or up to 400 hours of standby time. When the battery is discharged, the headset beeps every minute and the red indicator light flashes quickly. Switch on or off To switch on, press and hold the multifunction key for about 2 seconds.
connection separately after pairing. When the headset is connected to your phone and is ready for use, the green indicator light flashes slowly. Basic use Place the headset on the ear Calls To use the headset with the earloop, attach the earloop to it (8). To detach the earloop, gently pull it from the headset (9). Slide the earloop behind your ear (10), and point the headset toward your mouth. Carefully bend the earloop around your ear for the best fit (11).
To answer or end a call, press the multifunction key. To reject a call, press this key twice. To adjust the volume during a call, slide the volume key up or down. To mute or unmute the microphone during a call, briefly press the middle of the volume key. To switch a call from the headset to a compatible phone, press and hold the multifunction key for about 5 seconds (the headset switches off). To switch the call back to the headset, press the multifunction key for about 2 seconds (the headset switches on).
If a battery is being used for the first time or if the battery has not been used for a prolonged period, it may be necessary to connect the charger, then disconnect and reconnect it to begin charging the battery. If the battery is completely discharged, it may take several minutes before the charging indicator light is displayed. Unplug the charger from the electrical plug and the device when not in use.
Care and maintenance Your device is a product of superior design and craftsmanship and should be treated with care. The following suggestions will help you protect your warranty coverage. • Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits. If your device does get wet, allow it to dry completely. • Do not use or store the device in dusty, dirty areas. Its moving parts and electronic components can be damaged.