User's Manual

ManualsBrandsNokia Solutions and Networks ManualsElectronicsNon-Line of Sight Digital User Station

Table Of Contents

Section 7

Section 7 FCC ID: PHX-CPE25100

Users Manual – Regulatory Information

Section 7

Regulatory

Information

and

Users Manual

Motorola, Inc., NextNet Wireless Product Group

2900 County Rd 42 W

Burnsville, MN 55337 Page 1 of 5 8/30/2007

Summary of content (5 pages)

PAGE 1
Section 7 Users Manual – Regulatory Information FCC ID: PHX-CPE25100 Section 7 Regulatory Information and Users Manual Motorola, Inc.
PAGE 2
Section 7 Users Manual – Regulatory Information FCC ID: PHX-CPE25100 FCC / INDUSTRY CANADA INFORMATION NOTICE: This equipment has been tested and found to comply with the Radio Frequency Radiation Exposure Limits detailed below. A minimum of 20 centimetres (8 inches) separation between this device and the operator and all other persons should be maintained. This product complies with the requirements for Radio Frequency Radiation Hazard as defined in the FCC rules 47CFR1.1307 and 47CFR2.
PAGE 3
Section 7 Users Manual – Regulatory Information FCC ID: PHX-CPE25100 Declaration of Conformity Compliance Information Residential Subscriber Unit Model Numbers: RDMi25100 CPEi25100 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 4
A4 (210mm x 297mm) folds to A6 (105mm x 148mm) CPEi 100 Series MOTOROLA, Expedience and the Stylized M Logo are registered in the US Patent & Trademark Office. All other product or service names are the property of their respective owners. © Motorola, Inc., 2007. Cable Connection Guide Connect the cables in numerical order as shown.
PAGE 5
A4 (210mm x 297mm) folds to A6 (105mm x 148mm) Procedure to Install the Unit No software applications or drivers are loaded onto the computer.  Connect the Power cord and Ethernet cable to the CPE.  Plug the power cord into an AC outlet. The unit will turn on. Checking the CPE’s lights The lights on the CPE blink to indicate the strength of the signal received by the CPE. The CPE is equipped with an internal antenna that receives this signal from your Internet service provider.