INSTALLATION GUIDE NOKĒ PAD JULY 2019
BEFORE WE BEGIN PARTS Please make a note of all the parts which you have received. Below is the list of all parts that you would have received from Nokē. A: NOKĒ PAD B: BACK PLATE C: MOUNTING SCREWS AND ANCHORS D: TAMPER-PROOF SET: D SCREW AND ALLEN WRENCH A B C MOUNTING THE BACK PLATE Use the provided mounting screws to mount the back plate onto the desired surface. For mounting into surfaces like concrete or brick, you can use the provided plastic anchors to have a secure grip.
MOUNTING THE NOKĒ PAD Once the back plate has been mounted to the desired surface, mount the Nokē Pad onto the back plate such that the tabs in the Nokē Pad align with the slots in the back plate as shown below in the picture on the left. TAB / SLOT TAB / SLOT Once the tabs have been aligned with the slots, the Nokē Pad should be able to slide right around the back plate without much effort.
WIRING THE NOKĒ PAD The Nokē Pad requires a 12V or 24V DC power input. Connect the positive terminal of the power supply to the push pin connector marked by 24V. The ground terminal needs to connect to the port marked GND. See the image to the right for reference. RELAY OUTPUTS The Nokē Pad is designed to trigger the Relay 1 on the board when a correct number key is entered by the user. Relay 1’s outputs are mentioned as: RL1_NC, RL1_COM, RL1_NO.
UNLOCKING THE NOKĒ PAD The Nokē Pad can be unlocked via the app or with an access code. Access Code · Type in a 4-12 digit access code which has been configured in your Property Management Software. · The indicator light will flash green when unlocked. · After 5 seconds the Nokē Pad will automatically relock with a red light indicating the lock is engaged. Storage Smart Entry by Nokē App · Open the Storage Smart Entry by Nokē app. · Click on The Nokē Pad (identified by name).