N@NM NUT 4 Channel Marine 4” UTV/ATV/IBOAT Audio System with Bluetooth® OWNER’S MANUAL
Think yeu for making Ni your choir for marine audio entertainment! Hs compact, Marine design provides flexible mounting possibilities, and makes it simple expand the audio system capabilities of your vehicle. NUT 4 Channel Marine UTVIATV/BOAT Audio System with Blustosth® Ong Pair 4” 2.
What is included? When first unpacking your new amplified Marine speaker system, Please check first that the package contains all of the items below. if something is missing, contact the stare where you purchased the product. Nunavut ® One Pair 4” 2 Way Marine Speaker ® One Piece 4 Channel Marine Power Amplifier @ One Piece Bluetooth®eontrolier Installation precautions Before you drill or cut any holes, investigate your vehicle's layout very carefully.
SPEAKER INSTALLATION INSTRUCTIONS: ‘Please note: Thunderbolt Instructions (firs to tno actinium Sir ses; L501 75% dnd 27 but using the supplied subbed pads wil allow you 10 Mont these st speakers on any bar.sire Measured between 15" and 2° 2 Barges rei Ee ¥ YOU'LL NEED: H5 ALLEN WRENCH Reffing the tw sorrowfulness the bracket £6 separate the Speaker pod ard the bracket. YOU'LL NEED: 6” {150 mm) pads.
Power and Speaker Wiring WHITE NUTS AS AR hss + GREEN NOTE: ) Channels 1&3 {White & Green) are the % Right Cannes Channels {Gray & Purple) are the 4-8 ohm speakers Left Cannes Connect tithe Remote Control wire color Description Red Battery 12de { 12vde = ON Black Battery Ground White CH1 White/Black GH1{-) Gray GHZ Gray/Black GH2 {} Green CH3 Green/Black CHB (4) Purple CHa Blackcurrant GHA (4)
Nonfood& Background Light Next Song Volume lee) Conn gel to the Amplifier | ] Play {Pause Previous volume Down Song Bluetooth® Pairing and Connection: 1. Connect Bluetooth® controller box to your device 2. Crass and Hold O/ for three seconds until power indicator lights (red) % 3. The stern will automatically go into pairing mode The power indicator will turn red for about 46 seconds and then alternating red and blue (Bluetooth blue Power red} Please be sure that Bluetooth®is turned ON.
Bluetooth” Installation (MODE "Surface mount”) 1: Install" 2” shaped bracket threaded fea] ante the Bluetooth® controller hak, {packed with Incontrovertibly) Sheathe hole on the other brackets end ti isu the conditioner any screw/bolt and Washer will allover clean and days Surface mounting. 2: slide the Bluetooth® controller inch ihe hook. 3.