User's Manual

ZU15

1. General

This specification defines the performance characteristic of an DC/DC Car charger.

Car charger must comply with all the requirements of the specifications and drawing herein.

2. Electrical Performance and Tests

2.1 Input

Rated input voltage: Vdc 12V

Frequency: N/A

Current: 2500mAmax@ 12Vdc

Standby power: < 0.1W

Rating input load power: 27Wmax.

Starting time: < 1S@ 12Vdc Io = 100% load

2.2 Output

Voltage: 5.0V ± 5%

Current: Smart 4.8A max. for Iusb1+ Iusb2.

Ripple & noise: 120mVP-Pmax @ full load

Note: 20MHz bandwidth ripple & noise is measured by using 0.1uF C.C . & 10uF E.C.

bypassed at the output connector.

2.3 Short circuit protection

No damage to this power supply when output shorted to ground. When the short-circuited is

removed, the adapter shall promptly recover its normal operation.

3. Mechanical Tests and Requirements

3.1 Drop test

Drop height: 1.0m above 50mm hardwood.

Method: Total 6 times. Drop one time for each of the 6 case surfaces.

Expected result: After drop test, the unit should still operate properly. Small nick or slight

deformation may be accepted.

4. Environmental Conditions

4.1 Operating temperature

0°C ~ +40°C

4.2 Storage temperature

-20°C ~ +60°C

4.3 Humidity

90% RH Non-condensing

5. Mechanical Drawing

5.1 Dimension: 83.71mm x 18.01mm

5.2 Drawing

5.2.1 Switch adapter unit:

PAGE 1
ZU15 1. General This specification defines the performance characteristic of an DC/DC Car charger. Car charger must comply with all the requirements of the specifications and drawing herein. . 2. Electrical Performance and Tests 2.1 Input Rated input voltage: Vdc 12V Frequency: N/A Current: 2500mAmax@ 12Vdc Standby power: < 0.1W Rating input load power: 27Wmax. Starting time: < 1S@ 12Vdc Io = 100% load 2.2 Output Voltage: 5.0V ± 5% Current: Smart 4.8A max. for Iusb1+ Iusb2.
PAGE 2
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.