User Manual

EMOTE

PERATIONS

SSET

ANAGEMENT

ROAM Installation Manual

HL-2379_ver.02 2/08

Step 1

Scan the bar code affixed to the

bottom of the ROAM™ node ID

using handheld PDA.

Scan fixture attributes using hand-

held PDA and activation booklet.

Fixture attributes may include lamp

type, wattage, pole ID etc.

Insert photo control node into

twist locking receptacle on top

of the fixture.

Cover photo control device with

hand to shield light. Photo control is

functioning properly when fixture

illuminates.

Scan Node ID

Step 2

Scan Fixture Attributes

Step 3

Install Node on Fixture

Step 4

Test Node Functionality

PAGE 1
ROAM Installation Manual Step 1 Scan Node ID Scan the bar code affixed to the bottom of the ROAM™ node ID using handheld PDA. Step 2 Scan Fixture Attributes Scan fixture attributes using handheld PDA and activation booklet. Fixture attributes may include lamp type, wattage, pole ID etc. Step 3 Install Node on Fixture Insert photo control node into twist locking receptacle on top of the fixture. Step 4 Test Node Functionality Cover photo control device with hand to shield light.
PAGE 2
ROAM Installation Manual Specifications This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.