User Manual

ManualsBrandsNIVIS ManualsElectronics2.4 GHz Raptor RF Module

US Tech Test Report, FCC 15.247 B and C

FCC ID: SQB-NIVISMOD0002

Test Report Number: 08-0184

Issue Date: 24 September 2008

Customer: Nivis, LLC

Model: 2.4 GHz Raptor

Page 72 of 77

7 User’s Manual

Raptor RF Modem User’s Manual

Version 1.0

Created: September 29, 2008

Summary of content (6 pages)

PAGE 1
US Tech Test Report, FCC 15.247 B and C FCC ID: SQB-NIVISMOD0002 08-0184 24 September 2008 Nivis, LLC 2.4 GHz Raptor Test Report Number: Issue Date: Customer: Model: 7 User’s Manual Raptor RF Modem User’s Manual Version 1.
PAGE 2
User Manual Revision History Date 09/29/2008 Revision 1.
PAGE 3
User Manual Table of Contents 1. Purpose of Document.......................................................................................... 74 2. Overview of the Radio Modem Hardware........................................................... 74 3. Operation of the Nivis Radio Modem ................................................................. 77 3.1. Getting started .................................................................................................... 77 4.
PAGE 4
User Manual CON 1 Pin number Pin name Function of pin 1 2 3 4 5 6 7 8 9 10 11 GND GND NP NP NP NP GPIO1 GPIO2 RF-SCLK RF-MISO RF-MOSI Ground pin Ground pin NP NP NP NP GPIO GPIO SPI-CLK SPI-MISO SPI-MOSI Page 75 of 78 Min Voltage 0V 0V N/A N/A N/A N/A Vcc – 0.3 Vcc – 0.3 Vcc – 0.3 Vcc – 0.3 Vcc – 0.3 Nominal voltage 0V 0V N/A N/A N/A N/A Vcc Vcc Vcc Vcc Vcc Max voltage 0V 0V N/A N/A N/A N/A Vcc+0.3 Vcc+0.3 Vcc+0.3 Vcc+0.3 Vcc+0.
PAGE 5
User Manual Pins 1 and 2 must be supplied with 3.0 Volts and powers the digital and RF functional entities of the modem. The modem has internal filtering circuitry to smooth out the supply voltage but it has no onboard regulators. All of the remaining pins of the modem are I/O lines of the processor. The voltage on any of the I/O lines should never exceed VCC+0.3 V. Pins 1 and 3 are the TX and RX pins of UART 1. Pins 4 and 6 are the TX and RX of UART2.
PAGE 6
User Manual 6. Warning (Part 15.21) Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.