Total Biometric Solution Provider eNBio Gate User’s Manual V1.
Chapter 1. Installation 1.1 Connection 1.
1.1 Connection USB cable Remote controller Parallel & PS2 Audio signal Cable Video signal Cable 100/240 VAC * Connect the connectors like the upper picture.
1.2 Notices 1. Don’t change the USB port after the first installation into the user PC. 2. You must connect cables while the power of PC is OFF and the eNBio Gate power is also OFF. 3. You have to install the eNBio Gate in the place without strong backlight. It can make the camera movement error. 4. Don’t disassemble eNBio Gate without NITGEN’s approval. If do, you cannot have the A/S from us. 5.
Chapter 2. Usages 2.1 Enrollment 2.2 Verification 2.
2.1 Language Setting Language Setting You can choose the user interface language with buttons in the red circle in the upper Exit/Entry System UI.
2.2 Enrollment User data enrollment Enter a user’s data in the upper Exit/Entry System User Interface. If you adopt ‘Passport reader’, you can enter them automatically.
2.2 Enrollment Face Enrollment You can capture or delete a face image with the ‘Capture Face’ and ‘Delete Face’ buttons in the red circle of the ‘Exit/Entry System’ User Interface. And you can write the face template with the ‘Capture Face’ button. You can adjust camera heights automatically by pressing the ‘Auto’ button on the remote controller and manually with the ‘Up’ and ‘Down’ buttons.
2.2 Enrollment Fingerprint Enrollment Enroll the fingerprint template by using the ‘Issue fingerprint’ circled by red line in the upper UI.
2.2 Enrollment Enrollment Verification The upper picture is the state of the end of enrollment.
2.3 Verification Face Verification If you enter User Data or scan passport in the reader in verification mode, face and fingerprint verification is executed automatically in the turn.
2.3 Verification Fingerprint Verification If the message “Place your finger” is happen, place user fingers to the fingerprint sensors in the turn.
2.3 Verification Black List Search for Fail If the Verification result is fail, the message ‘The verification is fail’ is displayed. You can search the candidates by using searching Button in the upper UI.
2.4 Log DB Enrollment Log Search You can search Enrollment Log data for the various cases with the option check boxes in the upper picture.
2.4 Log DB Verification Log Search You can search Verification Log data for the various cases with the option check boxes in the upper picture.
Class B digital device or peripheral NOTE: this equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.