Date Rev 06/27/2016 10/15/2016 12/07/2017 03/28/2018 05/13/2018 1 2 A B C Revision Record Initial release Updates Released ECN 75574 ECN 75597 SPECIFICATIONS For APPROVAL Part No. 1505982-0002 New JRC Model No. NJR2830M HUGHES PROPRIETARY Copyright © 2016-2018 Hughes Network Systems, LLC Notice of Proprietary Information This document and its contents are proprietary to Hughes Network Systems, LLC and are intended solely for the internal use of Hughes Network Systems, LLC.
TABLE OF CONTENTS Section Sheet 1. 1.1 1.2 1.3 1.4 INTRODUCTION ..........................................................................................................................................................6 PURPOSE/SCOPE/RESTRICTED USES .......................................................................................................................6 REVISION HISTORY .........................................................................................................................
10.2 10.3 10.4 10.5 10.6 SAFETY AGENCY CERTIFICATIONS ......................................................................................................................24 EMISSIONS ...................................................................................................................................................................24 TYPE ACCEPTANCE ................................................................................................................................................
LIST OF FIGURES Figure Sheet Figure 3-1. LNA Context Diagram ................................................................................................... 14 Figure 4-1. LNA Block Diagram ....................................................................................................... 15 Figure 6-1. LNA External Interfaces ................................................................................................ 17 Figure 7-1. LNA (1505982-0002) Outline Drawing ..........................
LIST OF TABLES Table Sheet Table 1-1: Revision History ................................................................................................................ 6 Table 1-2: Applicable External Documents ....................................................................................... 7 Table 1-3: Applicable Internal Documents ...................................................................................... 10 Table 1-4: Terms, Abbreviations, Acronyms, and Definitions ...................
1. INTRODUCTION 1.1 PURPOSE/SCOPE/RESTRICTED USES 1.1.1 Purpose This document defines the functional and performance requirements for the Low Noise amplifier (LNA) for the RF Equipment used in a Ka-band Satellite Gateway. 1.1.2 Scope This document shall be used as the contractual performance requirement source for the design, development, fabrication, qualification, installation, and product acceptance activities pertaining to the procurement of the Low Noise amplifier.
1.3 APPLICABLE DOCUMENTS 1.3.1 Applicable External Documents Table 1-2: Applicable External Documents Item #. Document # Rev. Description 1. Directive 2005/20/EC Latest DIRECTIVE 2005/20/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 9 March 2005 amending Directive 94/62/EC on packaging and packaging waste 2.
Item #. Document # Rev. Description 15. UL 60950-1 2nd Edition 2007 Safety of Information Technology Equipment 16. UL 6500 Ed. 2 09/30/1999 Audio/Video and Musical Instrument Apparatus for Household, Commercial, and Similar General Use 17. CAN/CSAC22.2 NO. 60950-1-07 2007 Safety of Information Technology Equipment 18. IEC 61000-4-2 Edition 2.0 2008 Electromagnetic compatibility (EMC)- Part 4-2: Testing and measurement techniques - Electrostatic discharge immunity test 19.
Item #. Document # Rev. Description 29. EN61000-411:2004 Latest Electromagnetic compatibility, Electromagnetic radiation, Electromagnetic fields, Electrical equipment, Electronic equipment and components, Electrical testing, Voltage fluctuations, Low voltage, Testing conditions, Circuits 30. 6500 1.1.6 – 08/15/2001 Audio/Video and Musical Instrument Apparatus for Household, Commercial, and Similar General Use 31. UL 1409 32.
Item #. Document # Rev. Description 45. UL 60950-22 Latest Information Technology Equipment - Safety - Part 1: General Requirements Electromagnetic compatibility (EMC) - Part 4-5: Testing and measurement techniques - Surge immunity test 46. Latest 47. IEC 61000-4-5 ed.2.0 IEC 60068-2-27 Latest Environmental testing: Shock 48. IEC 60068-2-64 Latest Environmental testing: Vibration, broadband random 1.3.
1.4 TERMS, ABBREVIATIONS, ACRONYMS, AND DEFINITIONS Table 1-4: Terms, Abbreviations, Acronyms, and Definitions Terms / Acronym Definition/Descriptions ACU Antenna Control Unit AFR Annualized Failure Rate CFE Customer Furnished Equipment COTS Commercial Off-the-Shelf Cpk Process Capability index. Cpk of at least 1.33 is desired. CPL Critical Part List CW Continuous Wave dB Decibel: a logarithmic unit that expresses the ratio of two values of a physical quantity, often power or intensity.
Terms / Acronym Definition/Descriptions LEO Low Earth Orbit: altitude between 160 kilometers (99 mi) and 2,000 kilometers (1,200 mi) LHCP Left Hand Circular Polarization LNA Low Noise Amplifier LNB Low Noise Block Down-Converter M&C Monitor & Control ME Managed Element MES Manufacturing Execution System MPN Manufacturer Part Number MVT Manufacturing Verification Test NOC Network Operations Center NOCC Network Operations and Control Center NRTL Nationally Recognized Testing Laborator
2. MATERIAL The HNS material for each item defined in the document consists of the seven-digit drawing number, a hyphen, and a four digit extension (dash number); for example, 1505982-000x. The following materials are defined in this document. Note: Do not purchase any material per the MPN only; use the Material Dash # (MCN) Example: 1505982-0001 Table 2-1: Material Mat. Dash # 2.1 Long Desc. SAP Desc.
3. OVERWIEW 3.1 GATEWAY AND LNA The Low Noise amplifier (LNA) is an essential part of the satellite gateway receiver system. The LNA provides low noise amplification of the signal received from the satellite. Figure 3-1 depicts a simplified context diagram for the LNA in the Satellite gateway. LNA FEED LNA RADIO SIGNAL PROC. RF OUTPUT DC POWER Figure 3-1. LNA Context Diagram The LNA interfaces with the antenna feed and the Radio Signal Processor (RSP or Modems).
4. FUNCTIONAL DESCRIPTION AND REQUIREMENTS 4.1 FUNCTIONAL DESCRIPTION The Low Noise amplifier (LNA) allows the satellite gateway to receive RF signal from the satellite and amplifies to an acceptable level to the radio signal processor modem. 4.2 FUNCTIONAL REQUIREMENTS The Low Noise amplifier (LNA) block diagrams are shown in Figure 4-1. 1505982-0002 1505982-0001 RF INPUT RF OUT LNA Bias-T RF OUT RF INPUT LNA DC INPUT DC INPUT POWER POWER M&C Figure 4-1.
5. PERFORMANCE REQUIREMENTS Unless otherwise stated herein, the performance requirements in this chapter apply to all LNAs under all environmental conditions. 5.1 LNA PERFORMANCE REQUIREMENTS The LNA performance requirements are listed in Table 5-1. Table 5-1. LNA Performance Requirements Req. Number R5-01. R5-02. R5-03. Performance Parameter RF Input Frequency Range Gain Range Requirement 17.8 – 19.3 GHz 45 ± 2 dB At least 30 dB less than gain measured at 18.55 GHz ≤ 1.5 dB ≤ 1.75 dB R5-04.
6. INTERFACE REQUIREMENTS 6.1 EXTERNAL INTERFACES LNA key external interfaces are identified in Figure 6-1 and the interface spectrum is depicted in Figure 6-1. 1505982-0002 1505982-0001 RF OUT RF INPUT LNA RF OUT RF INPUT Bias-T LNA DC INPUT DC INPUT POWER POWER Figure 6-1. LNA External Interfaces R6-01. a. b. 6.2 RF Interfaces’ VSWR requirements are given below: Input VSWR shall be better than 1.8:1 Output VSWR shall be better than 1.45:1, with Goal of better than 1.3:1.
Req. Number R6-05. Name J2 Function LNA I/O DC Power Input & Fault Monitor Output Input / Output QTY Interface Description 1 DC Power Input & Fault Monitor Output (Input Voltage and Current Consumption.) Pin Assignment as shown in Table 6-3. LNA Connector IP67 rated 8-pin Connector (unterminated or open) BSD-08PMMSSS7001 Table 6-3. LNA DC Power and Monitor Interfaces (for 1505982-0002 only) 6.
7. MECHANICAL REQUIREMENTS 7.1 OVERVIEW The LNA shall be designed to support the operational, configuration, and performance requirements as defined in Table 7-1. Table 7-1 Physical Requirements 7.2 R7-01. The physical construction of the LNA shall support the requirements in their entirety as outlined in this document. R7-02. The physical partitioning of functional blocks shall be determined by considering: 1. Performance requirements 2. Ease of Installation and Maintainability 3.
Figure 7-1. LNA (1505982-0002) Outline Drawing No. 1505982 Rev.
7.3 MARKING AND LABELING 7.3.1 General The Marking and Labeling Requirements stated herein are included as guidelines to achieve successful implementation, deployment, and servicing of the Gateway RF equipment. R7-012. R7-013. R7-014. 7.3.2 Agency Certification R7-015. 7.3.3 All connectors shall be clearly marked. All Connectors shall be appropriately weather sealed. All units shall be labeled with HNS part number, revision number and serial number and barcode.
8. ENVIRONMENT REQUIREMENTS 8.1 OUTDOOR ENVIRONMENT The outdoor LNA shall comply with the outdoor requirements detailed in Sections 8.1.1 and 8.1.2. 8.1.
9. RELIABILITY REQUIREMENTS 9.1 DESIGN LIFE R10-01. The design life of the device shall be 10 years minimum when the system environment does not exceed the operational conditions as specified in Section 3 and Section 5. The design life is defined as all hardware remaining serviceable and operable at the specified performance level. 9.2 PRODUCTION LIFE Production Life is defined as the number of years the supplier is expected to support the product. R10-02.
10. AGENCY CERTIFICATION 10.1 GENERAL R10-01. R10-02. R10-03. The Agency Certification and Regulatory Standards stated herein are requirements for LNA deployed in the U.S.A., Canada, Mexico, and Europe. The LNA shall meet all applicable local, state, and federal regulations for the markets they serve. The LNA shall be CE marked. 10.2 SAFETY AGENCY CERTIFICATIONS R10-04.
10.5 IMMUNITY R10-07. The LNA shall meet the immunity requirements specified as detailed in Table 9-3. Immunity requirements in the European Union are covered by the EMC Directive 2004/108/EC Table 10-3 Immunity Requirement EN 55024 (Latest) Limits and Methods of Measurement of Immunity Characteristics of Information Technology Equipment – Same as CISPR 22 – Ed. 5 – 2005-04, amd.
11. QUALITY SYSTEM R11-01. Supplier shall be certified to the ISO 9001 Quality System and shall be subject to review by HNS. No. 1505982 Rev.
12. PACKAGING, SHIPPING AND LABELING 12.1 PACKAGING, SHIPPING, AND LABELING R12-01. The devices shall be individually packaged in containers suitable for protection of the components from damage during shipment in a railroad boxcar, ship, an enclosed truck, or by airfreight for either domestic or international shipment. R12-02. All packages will be labeled for identification of contents with the HNS material number. R12-03. A certificate of origin shall be included in each shipment. R12-04.
13. ENVIRONMENTAL REGULATORY REQUIREMENTS 13.1 WEEE REQUIREMENT Directive 2012/19/EC of the European Parliament and of the Council of 4 July 2012 on Waste Electrical and Electronic Equipment (WEEE). This Directive will be transposed into national law by 14 February 2014. At that time, the old Directive (2002/96/EC) will be repealed.
