Installation Instructions

MHz
FW D
RE F
NIODESKTOP - TB SERIES
FM TRANSMITTER
Intelligent
Alarm
PC Control
U Disk Player
Power
Adjustable
Stereo Sound
Wind Speed
Control
Imported Electronic
Component
U Disk Outlet
PC Control Power Socket
Cooling Fan
TNC Antenna Female seat
MHz
FWD
REF
Soundtrack Mode
U Disk Play
Alarm
Reflected Power
Transmit Power
Working Frequency
Function and Parameter setting
Precautions For Use
Power On/Off
When the machine is connected to power, then it starts.
In working condition, long press key, the machine enters standby mode.
In standby mode, long press key, the machine goes into working condition.
Frequency Adjustment
Power Adjustment
Soundtrack Adjustment
Amplifier Temperature
Audio / Microphone Volume Adjustment
Audio Volume Adjustment
Audio Socket
On/Off Setting Button
Down Button
Up Button Microphone socket Microphone Volume Adjustment
●There is high pressure inside the machine,maintenance can only be operated by professional
and technical person.
●Please put the machine in a cool dry and ventilated environment for use,the ambient
temperature should not be higher than 35 degree centigrades.
●After antenna installed,there should be 5 meters above from the ground and wall spacing as
standard installation environment.
●When install the feed tube,be sure to tie the feed tube to the mounting rod with a tie to prevent
the feed tube from pulling loose on the connector.
●Please do not turn on the machine without connecting the antenna.
●Please do not touch the antenna after machine is power on.
●Please do not use this machine in explosive antospheres(eg gas stations, gas,steam,etc.).
●Please comply with local radio regulations.
In working condition, short press , when the icon in the lower right 【 】 【 MHZ】button
corner flashes, press or to adjust the frequency.【 】 【 】button
Short press or , frequency steps by 100K;【 】 【 】button
Long press or button,frequency continuously steps by 100K. 【 】 【 】
Short press 【 】 【FWD】 【 】button, when the icon on the screen is flashing, press or
【 】 【 】 【 】 【REF】to adjust the power; Short press or button Decrement; icon is
displayed as reflected power.
PS:
The 6-watt power shows 0.75 watts per cell, with a minimum of 0 cells and a maximum of 8
cells.
The 15-watt power shows 1.9 watts per cell, with a minimum of 0 cells and a maximum of 8
cells.
In the working state, short press , when the icon of screen power icon is 【 】 【 】button
flashing, press or to adjust the channel mode; 【 】 【 】button
【 】 【 】is mono; When the stereo channel.
In working condition, short press button, when the icon is displayed, it is 【 】 【 】
the current temperature of the amplifier module.
Turn the audio knob / microphone knob clockwise to increase the volume;
turn counterclockwise to decrease the volume.