User's Manual

Remote Control Instructions
ITEM NO: YLT-22C
Specifications
Transmitter: 315MHz, remote range up to 80ft.(24.3m) using 1 CR2032 Lithium 3-volt battery
(included).
BATTERY INFORMATION AND REPLACEMENT:
1. On the bottom of the remote use your finger to depress the tab to slide out the battery holder.
2. Remove the used battery and insert a new 1 CR2032 Lithium 3-volt battery.
3. Slide the battery holder back inside so that the tab sets in place.
4. Dispose of old battery properly.
WARNNING:
Keep batteries away from children and pets.
Following the battery manufacturer’s safety unused for a long time.
Clean the battery contacts prior to battery installation.
Do not dipose batteries in fire. Batteries may explode or leak.
Notice:
Function range may be adversely affected by one or more of the following factors:
Orientation of the transmitter, weather, radio frequency interference, low transmitter battery and
obstructions between the transmitter and receiver.
NOTE: In case of power failure, the system will need to be reset.
Caution :
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Compliance statement:
1: This device is verified to comply with Part 15 of the FCC Rules. Operation subject to the follow
ing two conditions: (1) this device may not cause harmful interference, and (2) this device must ac
cept any interference received, including interference that may cause undesired operation.
2: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can ra
diate radio frequency energy and, if not installed and used in accordance with the instructions, ma
y cause harmful interference to radio communications. However,there is no guarantee that interfer
ence will not occur in a particular installation.If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the us
er is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is con
nected.
-- Consult the dealer or an experienced radio/TV technician for help.