User Manual

Operation Instruction:
In panel of transmitter , it has 2 buttons. Signification of buttons is: ON, OFF.
1.The general function of buttons:
a. ON : Press the transmitter key “ON” can turn into active the receiver.
b.OFF: Press the transmitter key “OFF” can turn into active the receiver.
2.Specification:
Electrical rating: 25VAC 5A resistive, 125VAC 600W Tungsten
Control distance: 60 feet
3.Installation:
1, One receiver supplied with transmitter.
2, Plug receiver into 3-wire outlet, make sure that the red indicator is lit, then plug the
lights or device to be switched into receiver.
3, The device must be mounted in a vertical position with the receptacle facing
downwards and not reaching the ground level.
4.Battery replacement:
1, Move the battery cover from back of transmitter.
2, Replace with type CR2032 3V battery.
3, Note polarity.
4, Dispose of old battery properly.
Caution :
Changes or modifications not expressly approved by the party responsible for compliance could void the us
er's authority to operate the equipment.