Instruction Manual



InstructionManualforRemoteControlTransmitter

ModelNo.:JHT2202

INSTALLATION:

Install one (1) x 12V (23A) battery in the compartment, make sure the installation of battery is correct.

OPERATION:

Transmitter with 2 buttons for individual ON and OFF function.

Each push of the ON or OFF button on remote controller will turn on or off the corresponding receivers

accordingly.

CHANGING THE BATTERY:

Regularly change the battery in the remote control for best use – however if you find the receivers are

not responding or the indicator light becomes dim then you must change the battery at the earliest

available time. Always dispose of old batteries with consideration for the environment.

TECHNICAL DATA:

Transmission frequency: 433.92MHz

Transmitter powered by: DC 12V 23A battery (1pc)

Product drawing:



FCC Caution:



Any Changes or modifications not expressly approved by the party responsible for compliance could void

the user's authority to operate the equipment.



This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

PAGE 1
Instruction Manual for Remote Control Transmitter Model No.: JHT2202 INSTALLATION: Install one (1) x 12V (23A) battery in the compartment, make sure the installation of battery is correct. OPERATION: Transmitter with 2 buttons for individual ON and OFF function. Each push of the ON or OFF button on remote controller will turn on or off the corresponding receivers accordingly.
PAGE 2
received, including interference that may cause undesired operation. IMPORTANT NOTE: Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.