User's Manual

Page 1 of 2
Instruction for Transmitter
Technical Index ：
 Working power: 12Vdc/23A
 Transmitting power: about 10mW
 Working temperature：-10°C to +70°C
 Working frequency：433.92MHz
Installation method:
 Should not let the emitter touch water.
 Avoid to static in the circuit, because the static will damage the electronic component and cause the remote control
failed.
 Should not let the emitter touch the metal object (if not, it will effect the transition of radio wave).
Application range:
Used in the electronic curtain/screens/doors and so on.
Instruction:
Ⅰ、 Function
1.1 The buttons on the emitter are “UP”, “STOP”, “DOWN”, “SET”, “CHANNEL SELECT”.
1.2 Press “UP”, the emitter will send the “up” instruction.
1.3 Press “STOP”, the emitter will send the “stop” instruction
1.4 Press “DOWN”, the emitter will send the “down” instruction.
1.5 Press “SET”, the emitter will send the “set” instruction.
When operating R type motor, the button “SET” can achieve the function “SET”, “DELETE”, “CONVERTING DIRECTION”,
“DOT CONTROL FUNCTION” and “APPENDING”.
1.6 Press “CHANNEL SELET”, see the details as below。
Ⅱ、 Channel select
The remote controls have single-channel, double channel, five channels, each indicator light show each channel.
Press the button “CHANNEL SELECT”, the light twinkle, then press the button again, the light will go to
another channel, so on an so forth, when the light twinkles on the right channel, don’t press the button,
then this channel is the channel you choose. When the indicator light are all twinkled, it is the function
of multi-control.