User Manual

DC1770
DC1770 back
DC1771 back
DC1771
Single - channel emitter
Double - channel emitter
setting button
（P2）
setting
button
（P2）
DC1770(B)/DC1771(B)
Emitter Specification
Type specification
Technical support
T
T
Version NO. : A/01
Fucntion instructionTechnical specification
Input voltage碋3V(CR2430)
Transmitting frequency碋433MHz
Transmitting power碋10 milliwatt
Operating temperature碋-5
0
C—50
0
C
Transmssion distance碋200 meters open office硽
35 meters on two walls
Transmitter: you can choose single channel DC1770(B), double
channels DC1771(B)
Notice: transmitter do not exposed to moisture and strike, so as not to affect life.
When you use transmitter, if found emission distance obviously short or less sensitive,
please change another same new battery. Please have batteries for recycling.
OK
OK
A
Additional
function
Matchable R tubular motor set up
ᴺ Delete all the datas of the motor and the
new emitter has been programmed.
ᴻ Each time, the interval of pressing different
buttons must within 4 seconds when you
re-setting all instructions, otherwise the system
will restore the original state.
OK
2
OK
Switch on
Hear long sound
Hear di di...
Press up button
one time, sound
tip three times
Set up is ok.
The up button control
the motor clockwise
Set up is ok.
The down button control
the motor clockwise
Press down button
one time, sound
tip three times
Sound from motor
hear long sound
Press the setting
button 2 times
A
Additional
function
Matchable DC1680 / DC1681 set up
ᴺ Each time, the interval of pressing different
buttons must within 6 seconds when you re-setting
all instructions, otherwise the system will restore
the original state.
ᴻ One receiver store 20 emitters channels at most
Switch
on
Press up button
and down button
one time at the
same time
Press the receiver
stop button one
time
Press the emitter
up button one
time
See indicator
flashing
See the receiver
indicator long
flashing
See indicator
flashing
Setting
is ok
A
Additional
function
Matchable DC136 set up
ᴺ Each time, the interval of pressing different
buttons must within 10 seconds when you re-setting
all instructions, otherwise the system will restore
the original state.
ᴻ One receiver store 20 emitters channels at most
Switch
on
Press the receiver
set button
Press the receiver
stop button one
time
Press the
emitter up
button one
time
See green
indicator
flashing
See the receiver
indicator long
flashing
See green
indicator
flashing and
extinguished
Setting
is ok
Up
button
Stop
button
Down
button
Up
button
Stop
button
Down
button
Up
button
Stop
button
Down
button
The second channelThe first channel