Installation Instructions

Electric winch wireless controller instructions

A, Features Overview

This wireless remote control firing frequency of 315MHz, the control range of more than

25 m, used in electric winch wireless control.

B, The wireless remote control parameters

1, Working voltage: DC6V, 2 pcs CR2032 battery.

2, The working current: 25mA ± 5mA

3, Transmitting frequency: 315MHz

4, The transmit power: <10dBm

5, Standby current: <5uA

Using

The remote controller have 1 key button and a switch. Press and hold the key button more

than 3 seconds, the remote powered on, while the LED indicator lights. Then press and

hold on the switch to "OUT" or "IN" side, it will trigger 315 MHz high frequency ASK

modulation unit to transmit the address code and key value. The high-frequency signal

emitted by the antenna. When the remote control has been powered on, press and hold the

key button more than 3 seconds, the remote control is turned off, while LED is off. If there is

no key operation within 50 seconds, it will automatically shut down.

D, Installation

and function

1,Disconnect Power to the winch

2,Confirm that the plug is the correct type for this winch and plug it in

3.Select an area for the receiver on the vehicle close enough to the winch to allow cable

connection

4.Investigate the chosen area to make sure no components will be damaged by installation.

5.Permanently (optional) mount the remote control receiver to the vehicle using appropriate

hardware (not included).

6.Preare the winch for operation as explained in its manual

7.Reconnect winch’s power

PAGE 1
Electric winch wireless controller instructions A, Features Overview This wireless remote control firing frequency of 315MHz, the control range of more than 25 m, used in electric winch wireless control. B, The wireless remote control parameters 1, Working voltage: DC6V, 2 pcs CR2032 battery. 2, The working current: 25mA ± 5mA 3, Transmitting frequency: 315MHz 4, The transmit power: <10dBm 5, Standby current: <5uA C, Using The remote controller have 1 key button and a switch.
PAGE 2
8.Release the clutch handle and pull out about 10 feet of wire rope Leave the wire rope laying on the ground and stay clear of the wire rope and hook 9.Reengage the clutch handle 10.Watch the spool and wire rope and briefly, press the out button on the remote control to verify that the cable feeds out WARNING! If the cable does not feed out ,check and correct the winch’s wiring. Retest after correction. 11.