Installation Instructions Part 2

ManualsBrandsNingbo Bird ManualsCell PhonesDual Band GSM Mobile Phone

5. Return the metal SIM holder to original

position and push it towards the top of the

phone until it locks into place.

6. Fit the battery and replace the back cover

by push and sliding it towards the top of the

phone.

Fitting Battery

Remove the back cover (see #1, Installing

SIM Card). Push the battery into place with

the label up and metal contacts at the

bottom right side in the back of the phone

until the battery fits into place, then replace

the back cover (see #6, Installing SIM Card).

Preparing Your Phone

Installing SIM Card

Please keep your SIM card away

from reach of children.

Scratches and bends can easily

damage the SIM card. Please be

extra careful when installing,

removing, handling or storing your

SIM card.

Before installing or removing the SIM

card, make sure the phone is

switched OFF, then remove the back

cover and battery.

1. Slide the back cover toward the bottom of

the phone until it can be removed;

2. Remove the battery (see Removing

Battery);

3. Push the metal SIM holder toward the

bottom of the phone and lift the released

end of the holder.

4. Place SIM card into the SIM holder with

the beveled corner at the bottom left corner

with the metal contacts face down.

Preparing Your Phone 15

Removing Battery

Remove the back cover (see #1,

Installing SIM Card) then push toward the

top of the phone and lift the battery at the at

the bottom side center to remove.

Settings and data stored in the

phone or SIM card may be lost after

the battery is removed.

Understanding Instruction Symbols

Symbols are used in this document:

press Left Soft Key

press Right Soft Key

press Up Navigator key

press Down Navigator key

press Left Navigator key

press Right Navigator key

press Call / Dial key

press End / On/Off key

press * key

press # key

press corresponding numeric key

Danger / warning

Tip / information

Network dependent feature

16 Preparing Your Phone

Summary of content (4 pages)

PAGE 1
Preparing Your Phone Installing SIM Card Please keep your SIM card away from reach of children. Scratches and bends can easily damage the SIM card. Please be extra careful when installing, removing, handling or storing your SIM card. Before installing or removing the SIM card, make sure the phone is switched OFF, then remove the back cover and battery. 1. Slide the back cover toward the bottom of the phone until it can be removed; 2. Remove the battery (see Removing Battery); 3.
PAGE 2
Receiving a Call When there is an incoming call, the phone will give corresponding alert according to your settings (such as Vibrate or Ring), If your network supports caller ID, the screen will display caller's name or number. You can answer the incoming call by pressing the or . If the headset is plugged-in, pressing on its button will answer the incoming call. Adjusting Call Volume Press the or to adjust earphone volume during call, there are 8 volume levels and select to choose from.
PAGE 3
PIN2 Code The PIN2 code is required when activating certain special features (such as call costs and fixed dialing). It is normally supplied with the SIM card package. Be careful while entering PIN2 code, 3 wrong tries in entering PIN2 code will block the SIM from use, requiring input of PUK2 code to unblock. Please contact your operator for further details. Phone Password The Phone Code is a 4 to 8 digit security code that protects unauthorized use of your phone. The factory default code is "0000".
PAGE 4
Charging Battery Insert the connector (if the connector position is wrong, it cannot be inserted, do not force it into the port, turn it around and try again) to the accessories port at the bottom side of the unit with the side having arrow or triangular marks on top, then plug the charger to an AC outlet having the SAME voltage rating; Charging may be done either when the phone is ON or OFF. During charging, the battery icon on the LCD will scroll until the battery is fully charged.