User Instructions

instructions

Model : BNR-U145Y

Technical parameters:

Battery parameters: 12V23A

Transmission frequency: 433.92MHz

Remote control by remote control handle:

Press the button on the remote control handle, the indicator light will be on, the

corresponding remote control signal will be emitted, and the control receiver will conduct

corresponding operation.

Battery replacement:

The remote control handle is powered by 12V23A battery. When the remote control

distance gets closer or when the button is pressed, there is no indicator light, please

replace the battery of the product, the battery model is 12V23A.

Open the battery cover plate on the back of the remote control handle by pressing down

and then pushing in the direction indicated by PUSH.

remove the old battery, according to the instructions of the battery polarity, the prepared

new battery according to the battery polarity into.

Push the battery cover into the product to complete the battery replacement.

Caution:

This device complies with Part 15 of the FCC Rules / Innovation, Science and

Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the

PAGE 1
instructions Model : BNR-U145Y Technical parameters: Battery parameters: 12V23A Transmission frequency: 433.92MHz Remote control by remote control handle: Press the button on the remote control handle, the indicator light will be on, the corresponding remote control signal will be emitted, and the control receiver will conduct corresponding operation. Battery replacement: The remote control handle is powered by 12V23A battery.
PAGE 2
following two conditions: (1) this device may not cause harmful interference. (2) this device must accept any interference received, including interference that may cause undesired operation. L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : 1. L’appareil ne doit pas produire de brouillage; 2.