User's Manual

Wireless Remote Control Socket Instruction Manual
Model no.: BH9906U
Please read the Instructions carefully before using the product.
Features:
◆
The sockets can be manually operated or via the handy Remote Control.
◆ Individual ON & OFF function for the remote control.
◆ Easy to use and operate. Use one transmitter to match more socket receivers or program more than
one transmitter to each socket. Any one transmitter and socket receiver can match use after finish programming
operation. So the socket receiver and remote control can sell separately.
◆The socket receiver will still remain in the “OFF” mode after a power out, even when the power comes on again.
Technical data:
Working Voltage for soc
ket…………………………………..120V~/60Hz
Receiver frequency…………………………………….. 433.92MHz
Max.load current……………………………....................... 10A
Detailed programming Operation:
■ Plug the remote controlled socket to a power point and turn the power on.
■ Press and hold the learning button on the right and side of the socket receiver for about 5 seconds till the LED
indicator flashes.
■ Release the learning button and press the preferred “ on” or “off” number button of the transmitter.
■ Programming successful when the LED indicator stops flashing.
■ The remote controlled socket is now ready to use.
■ Remote set up only requires one-time programming.
●
Pls note: The transmitter with 12V 23A battery is ready for learning operation in advance. Keep one hand press
the Learning button on socket, the other hand holds the transmitter.
NOTES:
●Make sure the battery and socket installation is firm, safe and correct.
●For indoor use only, it should be installed in the places of aeration and far from high-temperature source. Make sure
to avoid strong sunlight, raining and moisture places
●Do not exceed the maximum load current.
FCC Warning:
Changes or modifications to this unit not expressly approved by the party responsible for compliance will void the
user’s
authority to operate the equipment. Any change to the equipment will void FCC grant.
This device complies with part 15 of the
FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
●
●
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—
Consult the dealer or an experienced radio/TV technician for help.
●