User's Manual

ManualsBrandsNikko ManualsElectronicsTWIN TRUCK

1. Slide ON/OFF on bottom of chassis to ON.

2. Use the transmitter’s control levers to steer

your vehicle, as shown at left.

3. Slide ON/OFF on the vehicle to OFF when you

nish driving.

Wheel Alignment

If your vehicle does not drive in a straight

line when you release the right stick,

adjust WHEEL ALIGNMENT on bottom of

chassis. Push to L if the vehicle is pulling

to the right or to R if the vehicle is pulling

to the left.

driving your vehicle

Please read this user’s guide before

installing, setting up and using your new product

www.radioshack.com

Actual product may vary from the images found in this document.

60-4456

2-Pack 1:14 Scale Jeep & Hummer

RadioShack.com are trademarks

used by RadioShack Corporation.

60-4456

06A06

Printed in China

Hummer Jeep

Vehicle Antenna Tube (2) Transmitter (2)

Transmitter Antenna (2) User’s Guide

Thank you for purchasing your

2-Pack 1:14 Scale Jeep & Hummer from

RadioShack. Each vehicle has a different

frequency - 27MHz for the Hummer,

49MHz for the Jeep - so you and a friend

can drive together. The headlights turn

on as you drive forward and the taillights

turn on in reverse.

what’s included

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

• Consult your local RadioShack store or an experienced radio/TV technician

for help.

If you cannot eliminate the interference, the FCC requires that you stop

using your product. Changes or modications not expressly approved by

RadioShack may cause interference and void the user’s authority to operate

the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference,

and (2) This device must accept any interference received, including interference

that may cause undesired operation.

The carrier frequency ....................................................27.145MHz/49.86MHz

Field Strength ...................................................................<80 dBµV/m at 3m

Only use the antenna supplied with this product.

This radiocommunication device complies with all the requirements of Industry

Canada Standard RSS-310.

Ce dispositif de radiocommunication rencontre toutes les exigences de la

norme CNR-310 d’Industrie Canada.

This product is warranted by RadioShack against manufacturing defects in material

and workmanship under normal use for ninety (90) days from the date of purchase

from RadioShack company-owned stores and authorized RadioShack franchisees

and dealers. For complete warranty details and exclusions, check with your local

RadioShack store.

RadioShack Customer Relations

300 RadioShack Circle, Fort Worth, TX 76102 04/04

RF emission information

limited 90-day warranty

• Do not use your vehicle near devices with transmitters

using the same frequency (27 or 49 MHz).

• If someone uses a CB nearby, it might interfere with the

control of your vehicle. If this happens, move the vehicle

away from the CB.

• Never play with the vehicle in the street.

• Be careful when you use the vehicle to avoid high-impact

collisions with people and objects.

safety and care

In Your Transmitter

Insert one 9V battery (not supplied) in the battery

compartment matching the polarity symbols

(+ and -) marked inside.

In Your Vehicle

Turn off your vehicle. Insert six AA alkaline

batteries (not supplied) in the battery compartment

matching the polarity symbols (+ and -) marked

inside.

• If you do not plan to use your vehicle for a week or more, remove the batteries. Batteries can leak

chemicals that may damage electronic parts.

• Dispose of old batteries promptly and properly. Do not burn or bury them.

• Use only fresh batteries of the required size and recommended type.

• Do not mix old and new batteries, or batteries with different capacities or different chemistries.

• If your vehicle does not respond, drives slowly, or the range reduces, replace the batteries in your

vehicle.

battery notes

installing the batteries

Screw each

antenna into its

transmitter. Extend

to full height during

use.

Left Straight Right

Forward

Stop

Reverse

Thread each

vehicle’s antenna

wire through the

supplied antenna

tube. Then, insert the

tube into the antenna

tube holder on the

vehicle’s body.

60-4456 A3 edited.indd 1 06/19/2006 17:06:06