User's Manual

ManualsBrandsNikko ManualsElectronicsAston Martin DBS

Please read this user’s guide before

installing, setting up and using your new car

www.radioshack.com

60-4458

James Bond Aston Martin DBS

1:12 Scale RC Car

James Bond Aston Martin DBS Transmitter

Transmitter Antenna User’s guide

Vehicle Antenna Tube

what’s included

In your transmitter

Your transmitter requires one 9V alkaline

battery (not supplied). Replace the battery

when your transmitter’s control range

decreases.

1. Open the battery cover and insert the

battery as marked (+ and -).

2. Replace the cover.

In your vehicle

Your vehicle requires one 9.6V rechargeable

battery pack (not supplied).

1. Set ON/OFF on the vehicle under the body

on the driver’s side to OFF.

2. Use a coin to turn the battery compartment

latch to OPEN.

3. Slide the battery compartment cover in the

direction of the arrow and lift to open it.

4. Attach the vehicle’s connector to battery

pack. Do not force them; they t together

only one way.

5. Place the battery pack in the battery

compartment. The battery pack’s

connector must be on the same side as

the car’s matching connector.

6. Close the lid and snap it shut.

installing your batteries

• Do not use your vehicle near devices with

transmitters using the same frequency (27

or 49 MHz).

• If someone uses a CB nearby, it might

interfere with the control of your vehicle. If

this happens, move the vehicle away from

the CB.

• Never play with the vehicle in the street.

• Be careful when you use the vehicle to

avoid high-impact collisions with people

and objects.

• If your vehicle does not respond, drives

slowly, or the range reduces, recharge the

batteries in the vehicle.

safety information

Note: Actual product may vary from the images found in this document.

Thank you for purchasing your James

Bond Aston Martin DBS 1:12 Scale RC

Car from RadioShack. Your vehicle comes

in two frequencies (27MHz and 49MHz),

so you and your friends can drive your

car.

60-4458_UG_en.indd 1 08/22/2006 16:48:24

Summary of content (2 pages)

PAGE 1
60-4458 James Bond Aston Martin DBS 1:12 Scale RC Car Thank you for purchasing your James Bond Aston Martin DBS 1:12 Scale RC Car from RadioShack. Your vehicle comes in two frequencies (27MHz and 49MHz), so you and your friends can drive your car. installing your batteries In your transmitter Your transmitter requires one 9V alkaline battery (not supplied). Replace the battery when your transmitter’s control range decreases. 1. Open the battery cover and insert the battery as marked (+ and -). 2.
PAGE 2
driving your vehicle battery notes RF emission informations 1. Slide ON/OFF on the vehicle to ON. 2. Use the transmitter’s controls to steer your vehicle in the directions shown below. 3. Slide ON/OFF on the vehicle to OFF when you finish driving. • Dispose of old batteries promptly and properly. Do not burn or bury batteries. • Use only fresh batteries of the required size and recommended type. • Do not leave dead or weak batteries in your transmitter or vehicle.