NMD315 – Microset USER MANUAL EN © Elmarc, 32/07
Table of contents 1 Intended use 3 2 Safety 2.1 Labels in this manual 2.2 General safety 4 4 4 3 3.1 Unpacking 3.2 Package contents 6 6 6 4 4.1 Install 7 7 7 8 9 the system random equipment to the mains 5 5.1 Remote control 5.2 NMD315 Microset 10 10 12 6 6.1 6.2 6.3 6.4 6.5 6.6 13 13 17 21 22 23 25 General setup menu DVD/CD Copy content from a CD to a USB device Radio USB LINE-IN 7 Cleaning and maintenance 7.
1 Intended use The DVD Micro System plays music from CDs and music, videos and photos from DVDs and USB. Music can also be played via the LINE-IN port. The FM lets you listen to the radio. The appliance also plays photos from Kodak picture CDs. Read the manual carefully before the use. DVDs and DVD appliances are manufactured under the worldwide agreed DVD regional code system that the appliance will operate only with corresponding disc of the same regional code.
2 Safety 2.1 Labels in this manual WARNING A warning means that injury or death is possible if the are not obeyed. CAUTION A A note gives means that damage to the equipment is possible. e.g. for a procedure. 2.2 Please note! Install the product as indicated in this manual. If in doubt, consult a recognised technician and always take account of local codes and Warning! Do not install the product in any place that might be exposed to extreme heat or cold.
CAUTION Do not block the holes. This appliance is double insulated; therefore no earth wire is required. Always check that the mains voltage corresponds to the voltage on the plate. This appliance employs a laser system. To prevent direct exposure to the laser beam, do not open the appliance. Visible laser when open and interlock defeated.
3 3.1 Unpacking • Unpack the appliance carefully. • Check the package contents as described below. If any item is missing, please contact your reseller. • Remove the labels from the front panel carefully if present. We recommend that you retain the original carton and packing materials in case it ever becomes necessary to return your product for service. This is the only way to safely protect the product against damage in transit.
4 4.1 1 • Remove the • Insert the • Re-install the 2 3 cover. matching the (+) and (-) polarity markings. cover. CAUTION Incorrect can cause leakage and corrosion which will damage the appliance. Corrosion, leakage and any other gradually acidic defect of this nature will invalidate the guarantee. 4.2 • Connect the speakers to the appliance.
4.3 Connect the tv • Use one of the cables as presented in the image below.
4.4 • Connect the appliance to the mains. • Switch on the appliance.
5 5.1 Remote control 20 1 21 22 2 3 5 7 9 11 13 15 17 19 24 4 26 6 28 8 30 10 32 12 34 14 36 16 38 18 40 1. STANDBY 2. Digit 3. 10+ 4. PROGRAM 5. Stop 6. SOURCE 7. Arrow key up 8. MENU 9. Arrow key 10. ENTER 11. SETUP 12. MEMORY 13. SEARCH 14. SUBTITLE 15. ANGLE 16. COPY 17. N/P 18. ZOOM 19. V-MODE 20. MUTE 21. DVD/MEDIA 23 25 27 29 31 33 35 37 39 41 22. CH23. CH+ 24. FF+ 25. FF26. VOL+ 27. VOL28. FUNCTION 29. PLAY/PAUSE 30. TITLE 31. Arrow key right 32. Arrow key down 33. PBC 34.
• To select the source mode TUNER/LINE IN/DVD, press the SOURCE (6). TUNER DVD LINE IN • To select the source mode DVD, press the SOURCE • Press the DVD/MEDIA (21). (6). FUNCTION BASS and TREBLE can be adjusted using the FUNCTION (28) key. BASS • Press the FUNCTION (28) key 1 to select BASS. • Press the VOL+ (26) VOL- (27) key to set the BASS. TREBLE • Press the FUNCTION (28) key 2 to select TREBLE. • Press the VOL+ (26) VOL- (27) key to set the TREBLE.
5.2 NMD315 Microset 7 1 2 3 8 4 9 17 14 5 6 10 18 15 11 16 12 19 20 21 22 13 1. On / key (POWER) 2. LCD Display 3. FUNCTION 4. Stop 5. PREV/CH6. Volume dial 7. CD compartment 8. SOURCE 9. DVD/USB 10. Play/Pause 11. NEXT/CH+ 12. Headphone jack 13. USB slot 14. Line in jack to speakers 15. 16. AC~ POWER 17. Aerial (FM radio) 18. COMPONENT 19. AUDIO OUT 20. COAXIAL 21. VIDEO 22. S-VIDEO Headphone jack • To connect a headphone, insert the cable plug in the headphone jack.
6 All of the appliance are accessible using the remote control. All refer to with the remote control, unless indicated otherwise. 6.1 7 9 11 6 10 31 32 This chapter explains a complete setup of the appliance: screen display, audio setup and video setup. • • • • Turn on the television. Switch on the NMD315. To select the source mode DVD, press the SOURCE Press the SETUP (11). of (6). The Setup menu appears. General • Press the arrow and right) (9,31) to select a menu.
The GENERAL menu Picture format • In the TV DISPLAY press the arrow 4:3 4:3 PANSCAN or 4:3 LETTERBOX for a 16:9 for a wide screen TV set. (7,9,31,32) to select TV set. Select ANGLE MARK • In the ANGLE MARK press the arrow to switch this ON or OFF. When switched ON, the appliance shows the angle mark when angles are available. The ability to use this feature depends on the type of DVD. OSD LANG • In the OSD LANG language.
format (DTS/Dolby Digital 5.1). • Select SPDIF PCM to set the digital audio signal output to PCM format. The DOLBY DIGITAL menu Dolby digital audio setup DUAL MONO In the DUAL MONO area, you can choose: • STEREO: for stereo • L-Mono: channel only. • R-Mono: right channel only. • Mix-Mono: the average of both the and right channel. DYNAMIC • Select the value for the dynamic range compression to avoid losing sound details from a low volume.
The PREFERENCES menu Preference setup page TV TYPE • Select the video output format to match the appliance to the TV system: PAL, AUTO or NTSC. The video output format can only be selected when the DVD tray is empty. Please note: if the wrong has been selected, this may result in very poor image quality. In that case, select a AUDIO • In the AUDIO choose the audio language. SUBTITLE • In the SUBTITLE DISC MENU • In the DISC MENU choose the language. choose the language for the disc menu.
6.2 22 2 24 5 7 9 11 4 6 8 10 30 32 34 15 14 18 • • • • 36 23 25 29 31 33 35 37 41 Turn on the television. Switch on the NMD315. To select the source mode DVD, press the SOURCE Insert a CD/DVD. (6). the disc has been loaded, a content menu will display on the TV screen. • Press the arrow (7,9,31,32) to select a menu item. • Press the ENTER (10) to enter the selected menu item. • To start playback, press the PLAY/PAUSE (29) once.
• To select a chapter (DVD) or track (CD), press the digit (2). • To select the next or previous chapter (DVD) or track (CD), press the PREV (22) or the NEXT (23). • To forward or rewind the DVD, press the FWD (24) or the REV (25). The available speed rates are: 2x, 4x, 8x, 16x, 32x. • To pause playback, press the PLAY/PAUSE (29) once; to resume playback, press the again. • To stop playback temporarily, press the STOP (5) once.
Please note: Normally, if an MP3 disc is loaded, the unit will take longer to read the data. A DVD that does not match the region code cannot be read by this appliance. If a disc contains mixed content (e.g. MP3 and video the appliance will only recognise, list and play one content type. Program track sequence For video discs and audio CDs • To stop playback, press the STOP (5). • To play a list of tracks (max. 20) in a program, press the PROG (4).
This can be used for zooming in and out on photos and DVDs. The available zoom are: 2x, 3x, 4x, 1/2, 1/3, 1/4. • Press the ZOOM (18). • Press the ZOOM (30) again to set the correct size. • Press the arrow (7,9,31,32) to move through the picture. • Insert a Kodak picture CD. • Press the STOP (5) to enter the thumbnail mode. Choose an (Slide show/Menu/prev-next) and press ENTER (10). • Select an image using the arrow keys (7,9,31,32). Press ENTER (10) to view the image.
6.3 Copy content from a CD to a USB device Ensure there is free space on the USB device. 1 21 2 5 7 9 10 31 32 16 • • • • • Press the POWER (1). Press the DVD/MEDIA (21). Insert a CD. Press the STOP (5). Press the COPY (16). • Select the desired using the (7,9,31,32) keys. • Press the COPY (16). The contents of the USB device appear. • Press the ENTER (10). • Select ALL SELECT using the (7,9,31,32) keys. • Press the ENTER (10). • Press the COPY (16). The contents of the USB device appear.
6.4 22 2 24 23 25 6 12 13 • Press the SOURCE key (6) to select the radio mode. • Press the SEARCH (13). 20 are being searched and stored • Press the PREV (22) or the NEXT (23) desired • Turn on the television.
6.5 21 22 2 5 7 6 29 8 10 23 32 • Turn on the television. • Insert the USB device in the slot . The device can only be connected one way. • Press the SOURCE (6). • Press the DVD/MEDIA (21). the device has been connected, a content menu will display on the TV screen.
• Press the MENU playback. (8) to return to the content menu during • To select a track, press the PREV (22) or the NEXT (23) the desired track is set. • To pause playback, press the PLAY/PAUSE (29) once; to resume playback, press the again. • To stop playback, press the STOP (5). • To remove the device, gently pull it out of the slot.
6.6 LINE-IN 6 13 • To connect an external audio device, insert the cable plug in the LINEIN jack (). • To select the source mode LINE-IN, press the SOURCE (6). "LINE-IN" appears on the display.
7 Cleaning and maintenance WARNING Before performing any cleaning or maintenance, switch and unplug the appliance. • Clean the outside of the appliance with a cloth. When the appliance is very dirty, dampen the cloth slightly with water and a neutral 7.1 Handle and care of a disc Hold the disc with Hold the disc outer edge and/or the centre spindle hole. Do not touch the disc surface. Do not bend or press the disc. Do not expose the disc to direct sunlight or sources.
8 Technical data NMD315 Microset • Voltage: 220-240VAC ~ 50/60 Hz • Power ...
9 Disposal of used electric and electronic equipment The meaning of the symbol on the material, its accessory or packaging indicates that this product shall not be treated as household waste. Please, dispose of this equipment at your applicable point for the recycling of electrical and electronic equipments waste. In the European Union and Other European countries which there are separate systems for used electrical and electronic product.
